If you can't figure out how to remove the grill you have no business doing whatever it is you are doing.
The radiator is in the front, directly behind the lower front grille. It sits about 5 inches off the ground. To replace or repair the radiator, you must remove the front grille, the fenders, and the front wheels. See a Chilton manual for complete details.
If drainage is plugged under the grille adjacent to windshieldwipers, the water will drain into the floor of the front passenger seating area. Remove the grille and clear the plug. To avoid recurrence of this problem, clear leaves and other materials laying on the grille. Mike
Coupe? There are little screws on the underside that you'll have to reach under and remove with a small, short screwdriver. Sedan? I believe the grille is part of the bumper.
Under the front panel of the car
You will need to remove the 1998 Chevy Camaro brake light wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light.
Remove the water from your 1998 Chevy Camaro cooling system. Remove the water supply hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
remove radiator assembly/ disconnect all bolts/ lift it from top
No. The 1998 to 2002 hoods are sculptured in the front to fit the restyled headlights.
How to remove the front bumper to a 1998 Nissan Altima?
take it to a mechanic, or buy a hanes manual.
You'd also need fenders and hood from a 1998-2002 model for a satisfactory conversion
drivers side underneath right in front of the rear tire.
A 1998 Chevy Camaro uses R134a.
How do you remove the front axle on 1998 Honda 450 foreman?Read more: How_do_you_remove_the_front_axle_on_1998_Honda_450_foreman
Standing in front of the grille and looking underhood from the grille area - it's located on the firewall just about directly below the hub on which the passenger's windhsield wiper turns.
No, it will not fit without major modification. The front end of the 1993-1997 Camaro is much different from the 1998-2002 models. Any 1993-1997 Camaro bumper will fit the car in question without any modification unless the bumper was made by an after-market company. In that case, unless the company guarantees it, it may not fit properly.
Remove the tire and wheel from your 1998 Chevy Astro Van. Remove the brake spring and caliper. The brake pads will come off. Reverse the process to install the new front brakes.
First remove the grille, then the moulding above the lights. Next remove mouldings under the lights. There are bolts holding the assembly in the car. One, under the assembly, is deep and requires an extension on a 10 mm socket.