To remove the fuel filter on the late model Broncos first with the ignition off releive the fuel residual fuel pressure in the system. This is done by depressing the center ipn on a shrader valve on the fuel injector rail in the engine compartment. (it looks like a bicycle tire valve.) There will be some fuel leakage when this is done so lay some rags under it. Nest you will need a special tool. (not very expencive) This tool is a small plastic peice thet clips on over the fuel line and slides in to the round spring-loc flange and expands the internal spring allowing the filter to be separated from the main fuel line. I have used a home made tood made out of a peice of plactic fromm the side of a spray paint can cap. Cut a strip wrap it around the fuel line and slide in to the spring-loc fitting. To install the new filter remove the tool and simply snap the fuel filter in to the fuel line. You should not be able to separate them by hand once it is fitted correctly. When done turn the key on and inspect for leaks.
Chances are that there is a rubber O ring stuck in the channel the filter seats into. Remove the filter, take a scribe or something like a scribe and make sure there isn't an old O ring stuck up there.
In order to remove a stuck transmission filter from a case sl series 2 backhoe consult with an individual at one of the auto shops. The owner's manual will also provide the information needed to make this repair.
Use a strap wrench around the base.
Remove the oil filter and then remove the extra o-ring that's STUCK up in the engine block were the filter seats against. It should ONLY have ONE O-RING and that will set on the top of the oil filter.
use an oil filter remover, i find the strap type that uses a ratchet works best, the chain type distroys the filter and you get oil everywhere
The oil filter housing is plastic and is usually easy to remove with the correct cap wrench. If you use other means to loosen it, then damage may occur. I would have a spare housing handy.
your starter might be stuck on
inside the coupler is a green piece of plastic open it with small screwdriver. Pull the green piece up, but not out, from opposite side. Filter should come right out.
My oil filter is stuck on my 1995 Jimmy truck whats the best thing i can do?
To remove the stuck spark plugs, you can break them loose and then start to get them tighter as you rotate them out. The ratchet wrench can also be used to remove the stuck spark plugs.
You can unscrew your stuck oil filter with an oil filter wrench. If the oil filter wrench does not work, punch a metal rod through the oil filter. Turn the oil filter off with the metal rod.
In what?