Want this question answered?
i used a hammer
yup.
the glass door will not latch on to the tailgate of the jeep
this is the biggest pain i ever had to do when i had my bronco... but its simple, just take the plate off of the inside of the tailgate (tailgate could be up or down, down is easier), find the motor, unplug it and remove the couple bolts that are holding it in. careful not to cut yourself there isn't much room to work. the hardest part is getting it back in. good luck!
Yes. The Bronco body style didn't change again until after 1989.
All 1978 and later Ford Broncos have interchangeable tailgates. I found this out grom the junk yard when I was looking for a replacement tailgate for my 1978 Bronco.
It is located in the rear tailgate. Remove the inner panel and the support bracket on the right hand side to see it.
Open the tailgate, remove the retaining cables from the studs, pull out on the passenger side of the tailgate.
remove the carpet section on the inside cover , there are plastic plugs they just pop out , most will break but they are cheap and found in the auto parts help section, under that you will see a panel with several Phillips screws remove that cover and you will see the motor and mechanism if the motor is still good you can use a battery charger on the 2 wires in the tailgate one positive one negative, reversing will make it go up and down. there are 3 bolts on the motor , remove those and the glass will move by hand. be sure to support the glass when tailgate is down and glass is fully extended , i used a garbage can and a pillow. good luck
To remove the tailgate lock on a 1989 S-10 Blazer, first remove the cover over the inside of the tailgate by removing the bolts on the side and on the handle. Pop the vinyl away from the tailgate. Then remove the bolts holding the lock on and remove the lock.
cant open tailgate
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.