If your looking to replace the light bulb then you may have to remove the battery and then there should be a smaller round holister behind the light in the motor capartment all you should have to do is twist it off and then the light bulb should pull right out and then pull the bulb out of the holister (wiring harness) and then put the new one in and then put the holister back in the light assembley (it best not to touch the new light bulbs glass there are extremely fragile). If your going to replace the lense cover there are smaller bolts on the back side of the that you will have to remove to replace the lense, you may also have to remove a couple of bolts on the front by the grill (it can be a pain to replace the lense there is not alot of room to work inside the motor capartment it can be a real knuckle buster).
detach the bulbs and remove the clips behind the headlight assembly
it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it.
How to remove headlight assembly on 2003 Lexus GX470
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
How do you remove the headlight assembly on a 2001 camaro?"
Hi, You have to remove the entire headlight assembly to get to the bulb, which is located in the back of the assembly. There are three wing nuts that hold the assembly in, and those will have to be removed. Then remove the side signal assembly first, then the headlight assembly. I have provided a link that shows exactly how this is done and where these wing nuts are. Good Luck
There is no 1998 CTS
Open the hood, remove the two locks that hold the headlight assembly in place, with the two locks removed you can wiggle the headlight assembly out and gain access to the back side of the assembly to remove and replace the headlight bulb.
Begin by removing the wiring harness from the back of your headlight. Remove the headlight assembly retaining bolts. The headlight assembly will come out.
Open the hood to the engine compartment. Remove the headlight wiring harness. Remove the headlight assembly bolts. There are four headlight assembly bolts. The headlight assembly will come out.
Remove the wiring harness from your 2000 Kia headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
Remove the headlight assembly above the bad bulb to gain access to the burned out bulb. To remove the headlight assembly, open the hood, locate and remove the two tabs that lock and hold the assembly in place, with those tabs removed you can wiggle the headlight assembly out in the open. Now you can reach in and r & r the burned out signal bulb