most times you dont have to.. try to access it from the engine side of the light
All you will need to change the bulb is a screwdriver and a new bulb. Remove the headlight cover using the screwdriver and remove the burnt out bulb. Once out, you can insert a new bulb into the slot and replace the headlight cover.
Open Hood. Remove the cover from the headlight by prying up the keeper. Remove the metric 13 nuts holding the headlight in. Take out headlight and replace the bulb. Reinstall the headlight and reinstall headlight and cover.
Changing a headlight bulb in a 2007 Buick Lacrosse can be done easily. Just remove the cover piece and change the bulb.
To change the headlight bulb on a Pontiac Wave it is good to remember to not touch the new bulb with the fingers. Gently remove the headlight lamp cover (it should pop off after a gentle pull). Turn the old bulb and pull to remove it. Then, using the small plastic gripper (sold where headlights are sold) insert the new bulb and turn 1/4 turn. Replace the headlight lamp cover.
Just open the engine hood, and look behind either headlight that is out, and remove the cover behind the headlight, should probably be a turning cover, turn cover counter clockwise to remove, then un-plug connection for bulb, and remove light bulb. Light bulb will probably be held in by 2 metal spring clips, that are hooked in, just un-hook springs to remove bulb.
You probably don't remove the cover. The bulb is more than likely accessed from the back side. Read you owner's manual.
you need to remove the front fascia to remove the headlamp to change the bulb
The headlight is an assembly. To replace the headlight, you remove the bulb from the back side. It is a halogen bulb, so do not touch with bare hards before installing.
you can go to a auto shop and buy a rx300 bulb and after you can get someone to remove the headlight and you can remove the bulb and put the new one.
To change the headlight bulb on a 2003 VW Polo you must first remove the rubber cover from the back of the bulb. Pull off the connector and loosen the 2 torque screws to allow the black plastic locking to turn. Turn the locking ring counter-clockwise to remove and replace the bulb.
Take Out the battery box, then remove the battery, flip the locking clips on the headlight inside cover, then remove bulb holder twist and bulb can be removed
there are four screws holding the cover in place. Remove them and unscrew the cap covering the bulb. Use a screwdriver to pop wire off, it moves to the side. Remove bulb.