How do I remove the heatrest off of a 2000 LT Chevrolet Silverado
push pin in hole in plastic on bottom of head rest bar.
hoe do you remove headrest off 2002 Chevy cavaliers
To remove the front grill on a 2007 Chevrolet Tahoe the bumper will need to be removed first. After the bumper is removed, take off the four screws and clips holding the grill in place. The grill is then ready to remove.
Lift up the headrest to the highest position. The metal shafts have plastic rings that are part of the seat. Unscrew the rings counter clockwise around both shafts of the headrest and then pull headrest off.
Chevrolet does not use inertia/cutoff switches.
Replacing a battery in a 2001 Chevrolet Tahoe is very easy to do. You will just need to take off the battery cables off the battery and put them to the side. Remove the old battery and replace with the new one. Put the cables back on the correct posts.
Put a paperclip into the small holes on the side of the plastic at the seat.
remove the 2 18mm bolts off the caliper bracket, remove caliper, slide off rotor
Forgive me if you have tried this already , but have you moved the seat all the way back ?
Chevrolet does not use inertia or reset switches.
Take off the tire, remove the brake caliper, and pull off the rotor.
Keep pulling up. If your not sure try it on a different headrest.
The filter is up in the bottom of the transmission. You will have to take the transmission pan off of the bottom of the transmission to get to it.
no it does not, you will have to remove the fuel pump relay or fuse to shut it off.
Remove the battery cable, this is a sure way to get it to shut off.
remove the gas tank from under the truck or in some cases some shops will remove the bed off the truck Answer: You have to drop the entire gas tank and its on there. but there are a lot of things on it besides just the pump. i think the thermometor is on it too. but its all one unit. Good Luck
Chevrolet does not use inertia/safety switches. The fuel pump is computer controlled.
You have to have a very slim tool, I happened to have a very slim and narrow spatula, slide it down the front of the headrest support until you hit the mechanism inside and then pull it off while pushing down on the mechanism.
No there is not. But you can remove the fuel pump fuse to kill the pump.
Remove the tire and wheel from your 1999 Chevrolet Suburban. Remove the brake pads and break assembly. Tap on the rotor with a hammer or mallet. When the rotor is loose it will slide off.
On my F150 (2002 model), there is only one release button. My daughter had removed the headrest, and put it on backwards. It was locked in place, so I couldn't get it off until I noticed a little pinhole on the opposite side of the side with the release button. I inserted a paperclip into the pinhole, and it released the locking mechanism on that side so that the headrest could pop right off.
Perserverence paid off. 1. Raise Headrest 2. Unscrew 2 plastic retainer collars 3. Push down on cushion where guide post enter seat back and look for hairpin clips. (They are thin and difficult to see) Remove hairpin clips from each guide post and pull headrest up and out. A long thin needle nose pliers worked for me.
The light assy has to come off and there a couple of screws you get to from inside to remove the light.
Yes, You have to remove the intake to get the heads off.