You need a press, my advice is to go to NTB or sears and pay the 65 bucks to have this done right and fast takes no longer than an hour
Can figure out how to remove rear rotor assembly to replace wheel bearing assembly on a Maxima 2004 Nissan
The rear wheel bearing, on a Nissan Maxima, can be removed by first removing the rear wheel. Next, remove the axle cover. Slide the wheel bearing off of the axle. Reverse the process to install the new wheel bearing.
remove front door panel 1995 Nissan maxima
How do I remove An 87 Nissan maxima gas tank
I need a step-by-step how to change, remove and replace an alternator in an 1996 Nissan maxima
Remove engine, disassemble, replace piston, re-assemble engine and install. Good times!
what year maxima? please email email@example.com In i can tell you how to do it..
twist then pull
the acutually dash removal of the Comfort-Control Toggle Switch in order to remove facing for radio replacment of 1990 nissan maxima?
You pretty much have to remove the entire heater box under the dash on the passenger side
To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.
remove the whole front end
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
BIG JOB and you need to have the front end aligned before you drive it. TAke it to a garage.
Filters for a Nissan Maxima need to be changed every 15,000 miles. To change it remove the screws, release the retaining clips, and remove the glove box bulb.
Yes, an aftermarket stereo radio can replace a Bose radio in a 1997 Nissan Maxima. Remove the old radio from the dash and put in the new one. A new mounting frame might be required to make the new radio fit properly.
YOU FIRST HAVE TO DISCONNECT YOUR BATTERY. # Remove air duct assembly. # Disconnect starter harness. # Remove starter bolts (two). # Remove starter. #
you pull it out you pull it out
To replace a throw out bearing in any car or truck you must remove the gearbox, then remove the clutch, then pull the bearing out of the flywheel and replace it. Assemble in reverse order.
You can find the alternator on the front, right hand side, of your engine. Remove the cables from the alternator. Remove the belt. Remove the retaining nuts. Reverse the process to install the new alternator.
remove plastic moulding around door handle and door lock. unscrew door handle and unsnap plastic anchors around lower portion of door unscrew door panel from door. lift up on panel and remove. remove plastic. unscrew motor from door , let window down and remove two screws holding window. remove motor and metal bar replace and reverse process. 1991 Nissan maxima
Remove fuel tank, replace pump from top of tank, re-install. Change the fuel filter while your at it!
To remove a 1993 Nissan maxima rear speakers you will have to remove the seat back, you will need a wrench to remove both of the bolts on each side. The seat will move once done, and then pop the parcel shelf trim. The speakers should come out.
The 1990 Nissan Maxima came equipped with the 3.0L V6 and the RE4F02A automatic transmission. This type of transmission requires a professional tear down and overhaul to remove and replace the transmission filter assembly. It is not a standard pan filter with relatively easy access. The internal Maxima filter for the RE4F02A transmission is ATP part #B157.