Want this question answered?
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
Removing a ignition lock cylinder from a 2002 ford windstar with no key
Ford Festiva is car that is marketed by Ford between 1986 and 2002. The gap should be .040 on all V8 engines and the ignition gap for a 1998 5.2 is .040. There are no points in that vehicle. It has electronic ignition.
remove the two screws holding face plate in center of steering wheel and remove plate. next remove large nut in center. Using a steering wheel puller remove steering wheel. next there is a pin next tothe lock cylinder. that will have to be driven inwith a hammer and a punch. lock cylinder should be able to be pulled out. installation is the reverse of removal.
how do I remove the key switch from a 1998 ford contour You have to remove the plastic trim around the steering column (behind the steering wheel). Put the key in the ignition cylinder and turn one click. There is a small hole on the side of the ignition cylinder, stick a small screwdriver into this hole and press hard. Pull out the ignition cylinder with the key.
Number one cylinder is the cylinder on the far right (passenger side in US).
I'm working on a 1987 Festiva, and I *believe* that this is located inside the distributor housing.
There will be a pin on the front bottom of the cylinder housing. Turn the key to the on position then push the pin in and pull the cylinder out.
yes you do have to remove lock cylinder:first turn it to the off position and then under column is a hole.Take a pick or coathanger ,bend it straight to go inside hole and press against cylinder release button and pull cylinder out
The 1990 Ford Festiva 1.3 liter engine cylinder head bolt torque specification is 125 pounds. The cylinder head bolts should be torqued in 25 pound intervals.
rip it out or call a locksmith it happened with my 94 tbird