You don't have to remove the steering wheel to remove the ignition locl cylinder (mechanics will tell you otherwise). The lock cylinder is secured on to the steering column using two shear-off bolts (their heads shear off after a certain torque is applied while tightening them. So, you can not uncsrew them !). Kneeling by the drivers side door, I drilled a hole thru the side of the lock cylider all the way thru the bolt. First, I used a thin metal drill bit to start a hole and a larger drill bit (equal to the diameter of the bolt) later. I did the same to the other side of the lock cylinder. The lock cylinder will now fall off. This way, you don't have to remove the steering and mess with the air bag which is complicated. If you don't understand what I wrote, email me at myneic@Yahoo.com. I will email you a photo of the old lock cylinder where I made holes.
how to change a ignition switch on a nissan altima 2003
Take the steering column housing off (usually held by 4 screws from the bottom) and remove the starter cap from the back of the ignition cylinder. In a Nissan, the ignition cylinder usually has a T shaped pin which turns the starter. if you can start your vehicle by turning the starter cap with a screw driver, you probably don't have an issue with the starter.
How to remove the front bumper to a 1998 Nissan Altima?
how to remove a power steering pulley on a 1997 Nissan altima
how to open dash on nissan Altima 2008
how to replace a heater core on a 2003 Nissan Altima 2.5
Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.
u have to remove the rear deck lid, speakers r underneath how do you remove the rear deck lid on the 2005 Nissan altima
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
how do i remove the ignition switch in a 1995 Nissan quest
i luv biester
You will need to remove the retaining ring from the top of your 1975 Chevrolet pickup truck ignition cylinder. Slide the ignition cylinder out and remove the wiring harness. Reverse the process to install the new ignition cylinder.