Take of the plastic covering 3 screws on bottom, unscrew titlt wheel lever, turn key to on or start posistion there is a little metal clipon the bottom that you can pull out (not all the way) towards the key then on the back side of the cylinder you will see a lever in side a hole push it in the cylinder should come out
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
ignition what? coil, swicth,module, lock cylinder? gm Jim
I got a friend whose key can't turn the ignition on her 2000 Pontiac Grand Am. She can't get the steering wheel to unlock either.
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
how much to insall a ignition to a pontiac grand am se 1999?
Remove the instrument panel,take cover off on the front of the lock cylinder there are two 10mm bolts that mount it & remove it through the hole were the cluster sits..GM tech...
Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products. Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products.
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
In a 1988 Pontiac Grand Am you will find the clutch slave cylinder located on the flywheel. You will need to remove the hush panel from the driver's side foot well to gain access to the clutch slave cylinder.
you need to remove the top engine mount
You will need to remove the steering wheel and replace the ignition lock mechanism from inside. Unfortunately, with an air bag assembly, it is recommended that you take your vehicle to a trained technician so that the airbag doesn't deploy accidentally while you are working on it. The force can cause serious injury.
i just want to know how to remove the flywheel on a 1007 Grand AM Pontiac