Chevy Corvette
Honda Civic
1995-2005 Chevy Cavaliers

How do you remove the ignition switch from a 1992 Honda Civic?

202122

Top Answer
User Avatar
Wiki User
2008-04-07 05:42:45
2008-04-07 05:42:45

You need to turn the ignition to the on or start position, and then push the retaining pin to remove the cylinder.

If you can not turn it, then you can either drill it out, or call a locksmith to come asist you.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The Honda Civic 1.6 liter engine ignition switch is held in with a retaining ring. Unscrew the retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.

User Avatar

A 1999 Honda Civic Ignition switch is located under the steering column. Remove the steering column. The switch is seen connecting to the dash harness and lock cylinder. Unplug the switch from both places and replace with a new unit.

User Avatar

The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.

User Avatar

How many cuts are on the 05 Honda Civic

User Avatar

How do replace the ignition switch on 1995 Honda Civic EX with a manual tranny. I was wondering if it is pretty much the same as the 1995 Accord.

User Avatar

no the switch can be independly remove from the back side of the ignition lock

User Avatar

The blower motor relay switch in the Honda Civic is located at the center of the engine closest to the firewall. The relay is engaged when the ignition is turned to the on position.

User Avatar

it's located inside the steering column. Remove 3 screws on the lower steering column cover. Its the white plastic on the oposite side of the ignition.

User Avatar

In order to replace the ignition switch in a 1997 Honda CR-V, you must first unplug the ignition switch power source. Unscrew the cover panel, remove the bolts holding the switch, and pull the switch out of the column. Replace the old ignition switch with the new ignition switch, return the bolts and screws, and reconnect the power source.

User Avatar

It is under the driver side Dash its a black main relay!!!

User Avatar

How to remove factory stereo from 2001 honda civic?

User Avatar

To replace the wiper control switch in the 1996 Honda Civic, you must remove the steering wheel. With the wheel out of the way , remove the column covers and disconnect the electrical harness from the wiper switch. Remove respective screws and slide replacement switch into place. Replace respective screws, column cover and steering wheel.

User Avatar

how to change manual ignition switch on a 93 Honda accord

User Avatar

Try www.streetdreams.com/tech/honda/civic

User Avatar

how to replace the thermal switch relay on a 1992 Honda civic lx

User Avatar

The door switch on a 2002 Honda Civic is found inside the door panel. Remove all the mounting screws and gently pull the panel off. Find the door switch and unscrew it from the mounting bracket. Unplug and replace the switch.

User Avatar

the ignition module is located in the distributor

User Avatar

your local library may have a free shop manual to peek at.. good luck Dave

User Avatar

how do i deactivate the immobilizer from my honda civic 2006

User Avatar

a little 8 mill screw on bottom of rotor into dist shaft


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.