0
hey, if you mean the the little cylinder thing in your colum, i am working and stuck on that at the moment, you have to pull your steering wheel off, take your blinker etc stuff out, then there are like 5 little holes and in the bottom of one of them there is a screw, you have to take that out and then the cylinder should pull out
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change ignition switch on 1981 jeep wagoneer?
you must remove the steering wheel and turn signal from column. then you can acces the screw to remove the switch.
How do you remove the ignition switch key lock on a 1988 Jeep Cherokee?
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
How do you remove the ignition switch in a 1999 Jeep Grand Cherokee Laredo?
you take it to the dealer caz you cant do it for sure its incredably complicated
What does an ignition switch do for a 1997 jeep?
It engages and disengages the lock that starts the vehicle. There are 2 parts to the switch. The ignition switch and the lock assembly.
99 Jeep Cherokee Laredo stay running after turn off the ignition switch?
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
How do you replace the ignition switch on a 1989 Jeep Waggoner?
you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.
1988 jeep wrangler runs while cranking quits when you let off?
you have an open circut in your ignition switch change your ignition switch.
How do you remove the ignition switch on a 1991 Jeep Cherokee Sport?
changing the ignition switchfirst you have to take the steering wheel off.then you have to to have a tool called a steering wheel lock plate remocer/installer to remove the plate under the wheel .then you need to remove the turn signal switch (there is four screws holding it in , remember how you take it off )after that you have a little torx screw that you remove so you can slide the ignition out of the column .use the same directions in reverse to put the system back together with the new ignition switch
How do you change ignition switch on Jeep Comanche?
Do you mean the ignition key or the ignition switch? The ignition switch is located on the top of the steering column above the brake pedal. It's held on by 2 bolts. It's a lot easier to work on with the column removed. If you mean the ignition key. You need to remove the steering wheel, lock plate and turn signal switch. The key tumbler will either be held in by a screw or a tab on the tumbler. There are several sources on the Internet with detailed procedures.
Can you reset the oil light in a Jeep Liberty?
The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.
Why does my jeep run when you hold the key on but stalls when you let go?
You have a bad ignition switch
Your 1996 jeep 4 liter will only run if ignition key is kept in the start position?
Probably a bad ignition switch.
