Want this question answered?
you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.
you must remove the steering wheel and turn signal from column. then you can acces the screw to remove the switch.
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
you take it to the dealer caz you cant do it for sure its incredably complicated
either the ignition switch or the lock cylinder itself is bad. I would change both and check the rod that goes into the switch to make sure it is not binding up
It engages and disengages the lock that starts the vehicle. There are 2 parts to the switch. The ignition switch and the lock assembly.
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
you have a short or disconnected wire in the switch. you may need to replace your ignition switch. i have a 89 jeep and it was doin the same thing: it was the ignition module If one of the wires gets disconnected from the ballast resistor it will do the same thing.
you have an open circut in your ignition switch change your ignition switch.
No. A Jeep Wrangler does not have an inertia switch.
changing the ignition switchfirst you have to take the steering wheel off.then you have to to have a tool called a steering wheel lock plate remocer/installer to remove the plate under the wheel .then you need to remove the turn signal switch (there is four screws holding it in , remember how you take it off )after that you have a little torx screw that you remove so you can slide the ignition out of the column .use the same directions in reverse to put the system back together with the new ignition switch
Your Electronic Ignition Switch is bad. It is located on the inside of the jeep under your steering column.