Want this question answered?
hy i got the same problem mow i need a instrument cluster dont know wher to get one
lift the tailgate up,and you will see a Phillips screw or star screw,undo that then look up under the cluster from inside the hatch you will see a black plastic screw. undo that then pull cluster off from outside the hatch you will see where you change the bulbs.just reverse the procedure to assemble.
Open hatch and remove strap and handle. Remove rear panel attached to hatch by popping off of hatch. Be careful because the clips are not strong. Use bulb 921 @ 18W.
Chevrolet is the parent company of the Vectra C which was manufactured in 2002 through 2009. There were three basic models a four door sedan, a five door hatch back, and a five door station wagon.
Open the hatch - remove the protective cover from the housing - twist out the bulb holder - remove and replace bulb - re-install in the reverse order.
To remove the rear hatch door panel in order to fix the lock on a Subaru Outback you will need a Phillips-head screwdriver, small flat screwdriver, trim pry tool, and tack puller. Using these items you need to remove the push clips and pry the trim from the hatch.
Rear hatch leaking on 3rd gen Camaro,Z28-IRoc-z/Trans Am/Firebird-GTA The seal between the window and the hatch is worn. Any glass shop will reseal this.to do yourself buy a glass sealer or tar. remove inner hatch cover, there are I believe 4 bolts holding the window to the hatch. remove them. Have a large 4by4 holding up the hatch. Remove the hatch struts. Clean off old sealer under window an hatch. Reseal the hatch/window. Put the struts back and retighten all the bolts snug not too tight. I have had the same problem. This will fix ur water leak problem..
open the driver side door and you will see a little hatch , remove the hatch . its a little hatch located on the dash in the dorr jam. remove it and you will see 2 wires running into a metal heatsink. just unplug harness. Brian Z.
Open the glove box, squeeze the sides in and remove the glove box (easy to re-install). Behind you will see a long horizontal rectangular hatch. Depress the plastic latch and remove the hatch. Remove old filter, clean out any loose debris, replace with new filter. Put the hatch and glove box back in and you are done.
A pipe inside the rear hatch has diconnected, simply remove the plastic inner panel inside the hatch and reconnect
To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.
open the hatch there are two screws remove them and the tail light will come out, after that there are three more screws remove them and you can get to the bulbs to replace them