open the hatch there are two screws remove them and the tail light will come out, after that there are three more screws remove them and you can get to the bulbs to replace them
103ftlbs
Yes
simply remove the two screws located on the top of the headlamp assembly and then pull the headlamp assembly forward to gain access to the light bulbs
you have to remove the headlight assembly 3little bolts
remove and replace engine coolant temperature(ect)/chevy 2004 trailblazer
To remove the taillight assembly on a 1997 Infiniti Qx4, the lining for the cargo area needs to be removed. Push down, and turn the plastic rivets in the corner of the cargo area. Then remove the cover over the taillight bulb.
Lift the hatch. Remove the screws in the tail light assembly. Pull the tail light assembly out. It may need a gentle nudge. Now untwist the bulb assembly socket counter clockwise to remove. Replace bulb. Re assembly is in the reverse order.
If you can't reach inside and remove the rubber boot covering the back of the headlight assembly then do the following. Pull off the grill being careful not to break the clips or the plastic. Use a screwdriver to slide the dagger clips out that hold in the headlight assembly. You can see the tabs on the top inside and on the outside sides of the headlight assembly The headlight assembly will fall forward but you might have to remove the side marker light as the wires are very short. Now you should have easy access to the boots covering the bulbs. All bulbs remove with a twist and have tabs on them. www.trailvoy.com Trailblazer enthusiasts forum!
If you open tailgate there should be 2 black screws against rear fender - remove these and assembly should pull-out
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
It's very easy. Open rear hatch. Remove two screws under the light assembly. Pull the unit out. It might take some wiggling to get it past the hatch. Remove grey connector and install new light assembly.
To replace the daytime running light on a 2004 Suburban, you will have to first remove the two metal pins that can be found on top of the headlight. The headlight assembly can be removed next. Pull out the plugs that are connected to the headlight assembly. Replace the bulbs and then reconnect the assembly.