To remove the taillight assembly on a 1997 Infiniti Qx4, the lining for the cargo area needs to be removed. Push down, and turn the plastic rivets in the corner of the cargo area. Then remove the cover over the taillight bulb.
The tail light assembly on a 2004 Chevy Suburban can be removed by taking out the retaining screws and twisting the bulb assembly. The assembly can then be pulled from the vehicle.
To replace the daytime running light on a 2004 Suburban, you will have to first remove the two metal pins that can be found on top of the headlight. The headlight assembly can be removed next. Pull out the plugs that are connected to the headlight assembly. Replace the bulbs and then reconnect the assembly.
It's very easy. Open rear hatch. Remove two screws under the light assembly. Pull the unit out. It might take some wiggling to get it past the hatch. Remove grey connector and install new light assembly.
if it is an LED unit you cant you have to change the assembly as a unit
What sequence is used to remove radio from 2004 sububan
simply remove the two screws located on the top of the headlamp assembly and then pull the headlamp assembly forward to gain access to the light bulbs
you have to remove the headlight assembly 3little bolts
open the hatch there are two screws remove them and the tail light will come out, after that there are three more screws remove them and you can get to the bulbs to replace them
Lift the hatch. Remove the screws in the tail light assembly. Pull the tail light assembly out. It may need a gentle nudge. Now untwist the bulb assembly socket counter clockwise to remove. Replace bulb. Re assembly is in the reverse order.
If you open tailgate there should be 2 black screws against rear fender - remove these and assembly should pull-out
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
You have to remove the whole headlamp assembly. Remove the 1 bolt 6mm? and pull outwards.
First remove the 2 l rods to remove the headlight assembly then look down behind the marker and turn signal look for a push in clip near the fender just squeeze it and at the same time pull out on the lens . the light is in that lens closest to the grill.