When your transmission is in park, it has a key release switch that can get corroded over time. I cleaned mine on my older Audi. You might be able to do that on yours.
If it is intermittent, run the lever from park to neutral, then back to park. Turn the key to start, but do not start the car. turn the key back to the off position. It should then pull out.
1996 rodeo- how to remove key from lock ignition?
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
how to remove key stuck in ignition switch in Chevy colbalt
You have to have the key to that ignition to remove it. You can get a locksmith maybe. The dealership can make you a key from your vin# definitely good luck.
Find and remove the chime.
Remove the retaining ring from the top of your 1977 Chevrolet pickup truck ignition key tumbler. Slide the ignition key tumbler out. Remove the wiring harness from the end of the key tumbler.
Use the opportunity to replace the ignition. Key needs to be in On position for removal.
Removing a ignition lock cylinder from a 2002 ford windstar with no key
To remove the "key" ignition, insert a small screwdrived in the hole directly below the ignition in the column. You will need to have the key in the ON position otherwise the ignition will not come out of the column.
i have a 06 Chevy cobalt and can't get the key out of the ignition switch
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.