answersLogoWhite
Ford Aerostar
Ford Aerostar XL
Ford Aerostar XLT

How do you remove the modulator on a Ford Aerostar transmission?

818283

Top Answer
User Avatar
Wiki User
2015-07-15 20:48:47
2015-07-15 20:48:47

The modulator is held into the transmission with a stamped metal "fork" that is bolted into the transmission. Remove the bolt, remove the vaccum hose and wiggle/turn the modulator to extract it. Be careful during the removal because there is a short pin in the modulator that has to be replaced when you put the new one in.

.

1

Related Questions

User Avatar

On a 1993 Ford Aerostar : The automatic transmission modulator is on the passenger side of the transmission ( it might be behind a heat shield )

User Avatar

The transmission modulator on a 1994 Ford Aerostar is on the passenger side of transmission behind catalytic converter. To remove you will need a 10mm socket with an extension long enough to reach over exaust pipe(easiest way).

User Avatar

On the Ford A4LD automatic transmission the modulator valve is on the passenger side of the transmission ( it might be behind a heat shield )

User Avatar

on the passenger side of the transmission about 2/3 thirds of the way back it will have a vaccume line hooked to it !

User Avatar

Transmission Modulator 1996 ford mustang can not find location

User Avatar

How do you remove the rotors on a 1992 ford aerostar?"

User Avatar

The exact location of the transmission modulator valve on your Ford Mustang is dependent upon the year of the Mustang. Most of the time the transmission modulator valve will be on the back of the transmission.

User Avatar

I'm not a mechanic / technician but I believe it can if the automatic transmission uses a modulator valve that has a vacuum line connected to it because the vacuum comes from the engine . If there is a problem with the modulator valve then the transmission fluid could be sucked into the engine

User Avatar

Will a 1997 Aerostar transmission fit in a 2000 ford ranger?

User Avatar

Need to be more specific. What modulator?

User Avatar

If you mean the modulator valve for the transmission its on the side of the transmission. Under the car.New Answerthe 1987 ford crown vic with a AOD overdrive transmission does not have a modulator valve

User Avatar

On a 1992 Ford Explorer ( A4LD automatic transmission ) I believe the modulator valve is on the passenger side of the transmission , BEHIND a heat shield

User Avatar

On a 1994 Ford Explorer : The modulator valve is on the outside of the A4LD automatic transmission , on the passenger side of the transmission , I believe it is behind a heat shield

User Avatar

Starting with the 1995 Ford Explorer model the transmission is ELECTRONICALLY controlled ( so there is no vacuum modulator )

User Avatar

A modulator valve is located inside the case, in front of the modulator.

User Avatar

where to put transmission fluid at in 93 ford areo star

User Avatar

Remove the battery cables. Remove the battery tiedown. Remove the battery from the Aerostar. Reinstall in reverse order.

User Avatar

Starting with the 1995 model of Ford Explorer the automatic transmission was ELECTRONICALLY controlled , so there is no modulator valve

User Avatar

The vacuum modulator is a small canister on the the side or rear of the transmission case depending on the model transmission.It is retained into the transmission by a clip that is retained to the case by screw or bolt.TO replace:Remove vacuum line from modulator, inspect line for cracks, damage etc.remove the screw or bolt holding the clip and retaining in the modulator.Inspect the new modulator to insure the "O" ring is in place on the portion that goes into the transmissioncarefully pull the modulator out of the bore in the case. At this point the transmission will probably leak some oilPush the new one in the holeRetain with clip and screw or bolt.Plug in the vacuum line

User Avatar

For a manual transmission: 5.6 pints. For an automatic transmission: 19 pints.

User Avatar

The vacuum modulator on aÊ2001 Ford Windstar is located in the front left area under the hood. It is connected to the transmission by wires and tubing.

User Avatar

No, they are two completely different designs. aerostar is rear wheel drive ,taurus front wheel drive.

User Avatar

The back up light switch on the 1994 Ford Aerostar is located on the side of the transmission. To remove it the wires must first be unplugged. Next the all screws must be removed.

User Avatar

A 1994 Ford Aerostar manual transmission will hold 1.2 liters of API GL-5 SAE 80W90 transmission oil. An automatic will hold 10 quarts if the lines are completely flushed.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.