Chevy Camaro
Ford Aerostar XLT
Ford F-250

How do you remove the motor mounts on a 1986 Chevy Camaro?

252627

Top Answer
User Avatar
Wiki User
2008-01-06 06:35:46
2008-01-06 06:35:46

# Remove the through bolt and nut # Raise the engine slightly using a jack with a wood block under the oil pan then remove the mount and frame bracket assembly from the crossmember

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

it will fit. you will have to use camaro frame mounts.

User Avatar

Yes, you have to change the Motor Mounts and get the correct headers but it will fit.

User Avatar

yes you can, you will just need the big block motor mounts to do it.

User Avatar

How many motor mounts in 2004 Chevy Malibu?

User Avatar

sure if you change the motor mounts.

User Avatar

yes the 4.3L vortech has the same motor mounts as the 350

User Avatar

Jack up the motor and replace them. Center of the motor on the sides. Use a block of wood on a floor jack and lift on the oil pan,

User Avatar

Remove the wiring harness from the back of your 1980 Chevy Camaro heater blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.

User Avatar

If the Buick 305 is really a Chevy 305, then the motor mounts will interchange with a Chevy 350.

User Avatar

any size Chevy engine you want to put in it will fit, you just have to change motor mounts.

User Avatar

I need instructions on how to change the window motor in 1995 Chevy Camaro.

User Avatar

Sure it will, just get your motor mounts made and swap the motors

User Avatar

No, the last year for a 3400 motor in a Camaro was 1996.

User Avatar

No. You will have to get v-8 mounts.

User Avatar

You will have to remove the exaust that is in the way. then you will have to remove the motor mounts to raise the engine. after all of this then you can take the pan off.

User Avatar

There is no fixing broken motor mounts. Replace them with new ones.

User Avatar

Show me you how to install window motor for 1992 Chevy camaro

User Avatar

If it is the LS1 why bother? If it is a V6 than you will have to mock up the motor mounts to the right place. You will also need a trans, driveshaft and modifications to the fuel system.

User Avatar

It is not required to support the motor when you remove the upper front mounts. The engine will rock a bit but it will not move substantially. Just remember to reattach the mounts when finished.

User Avatar

no because the 2003 is bigger you wouuld have to cut it to get it to fit

User Avatar

Theres bound to be changes but for the most part the only think it comes to mined Motor Mounts.

User Avatar

A 5.7 litre or Chevy 350 will fit as that's what the Z28 has in it, you will have to change motor mounts and all the computer wiring and computer to do it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.