answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2012-04-15 21:47:25
2012-04-15 21:47:25

The best way to change the oil on a Craftsman Eager One lawn mower - 6.75 HP is to buy a Toro.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Remove drain plug and allow oil to drain. Insert drain plug. Remove fill plug and fill with the appropriate type and amount of oil. Install fill plug.


According to my Sears manual, there is no drain plug. You need to remove the oil dipstick and tip the mower on its side so that the oil will drain out of the fill location. It is odd, but that is how you do it.


Simply remove the dipstick or screw on oil filler cover and tip the mower on its side and dump it into a suitable container.


You have to remove the pan to drain the transmission.You have to remove the pan to drain the transmission.


You remove the pan on the bottom to drain.You remove the pan on the bottom to drain.


Locate oil drain , usually a small pipe with a cap on it, open it, remove the dip stick let drain, replace cap , fill to dip stick level,


The engine has a drain plug located on the engine block. Look closely and you will find it.


Usually, yes. You either remove a drain plug, or the trans pan to drain.Usually, yes. You either remove a drain plug, or the trans pan to drain.


Remove the oil pan drain plug to drain the oil. Remove the lower radiator hose to drain the coolant.


Once the old tub gets into the drain it is impossible to remove.........


On a Kohler engine there is usually a drian plug on the left side of the engine (drivers side) near the rear of the engine. It is right in front of the oil filter. The oil filter base has a small plug in it that you will need to remove also to drain the filter base after you remove the oil filter.


To change the oil on a Craftsman 6.5 hp log splitter you first need to drain the current oil. The drain plug is on the bottom of the engine crankcase. Once drained, replace the drain plug and fill with new oil via the dipstick tube.


There is no drain plug, you must remove the transmission panThere is no drain plug, you must remove the transmission pan


It will be located somewhere on the lowest part of the engine block.


Remove the lower bolt in the pto cover to drain.Remove the lower bolt in the pto cover to drain.


Remove the tank and drain it unless it has a drain plug on the bottom of the tank.


Remove the drain plug from the bottom of the oil pan, and then remove the filter.


Unhook the drain from below the sink


You have to remove the tank and pump. You can than drain from the hole the pump was in.You have to remove the tank and pump. You can than drain from the hole the pump was in.


On the automatic trans, you will have to remove the pan to drain.On the automatic trans, you will have to remove the pan to drain.


You can drain it from the bottom. You will need to remove the bottom under panel, should be 6 8mm bolts, then you can see the drain bolt, remove the drain bolt and you can drain the oil.


There isn't one, you have to remove the differential cover to drain the fluid.There isn't one, you have to remove the differential cover to drain the fluid.


There is no drain plug. You remove the pan to drain.


The engine oil drain plug is on the bottom rear of the engine oil pan. The transmission does not have a drain plug, you remove the pan to drain.The engine oil drain plug is on the bottom rear of the engine oil pan. The transmission does not have a drain plug, you remove the pan to drain.


It does not have a drain plug. You have to remove the pan to drain fluid.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.