0
It takes a special socket and it will unthread counterclockwise. Use of pliers may damage the sending unit.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change oil sensor on 1996 Chevy s10?
If that S10 has a 4.3 engine, I find it best to remove the distributor to gain better access to the oil pressure sensor.
How do you test a 4.3 chev oil pressure sensor?
If it is a 1997 S10 4.3, with the engine running, remove the fuel pump relay, if the engines stops running, the oil pressure sensor is bad.
What is the sensor in the block by the oil filter on your 1993 s10?
knock sensor
What is the location of the oil pressure sensor in a 1991 s10 blazer?
it is under the distributor.
Replace water temp sensor on Chevy S10?
Remove the tail gate then replace water temperature sensor.
How do i remove oil level sensor 1992 Buick Roadmaster?
It is not an oil level sensor it is an oil pressure sensor. It just unscrews.
How do you replace crankshaft sensor on 2001 s10 blazer?
Locate the crank sensor behind the vibration damper (crankshaft pulley). Unplug the wire harness connected to it. Remove the small bolt holding the sensor in place. Remove the sensor.
How to Drain oil on 91 S10 Blazer?
To drain the oil on a 1991 Chevy S10 Blazer, located the oil pan drain plug. Use a wrench to remove the plug and the oil will flow into the receptacle you have provided.
How do you find the oil pressure sensor on a 96 Chevy S10 Blazer 4.3 6 cylinder engine?
It is about 3 inches long with an electrical connector on the end of it. It is back by the right hand side of the distributor. Hard to see.
Where is the MAF sensor located on a 1994 Chevy s10?
The 1994 S10 uses a MAP sensor, not a MAF sensor. We need to know size engine you have in that S10.
How do you change the oil on a 1995 S10 blazer?
Drain oil from oil pan, remove oil filter through access door unde raditator.
Where is the oil sensor unit located in a 1992 blazer S10?
Depends on which motor? On the 4.3 v6 it is next the dist.
