Pop off the plastic triangle piece at the rear view mirror, and below this on the panel is a round cover about the size of a dime, pop it out and remove the screw. Remove the screw under the arm rest and remove it and the screws under it. The panel will need to be poped out at the botton with a thin tool. The panel should lift up and out from there.
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
you need to pull the plastic off on the inside of the car to access it.
from inside the trunk pop all of the plastic rivots and you can access the bulbs from the inside..
If you have access to the vehicles; it will be listed on the tag on the inside of the drivers door.................
Inside the left front fender, remove the inner plastic fender liner to access.Inside the left front fender, remove the inner plastic fender liner to access.
On the back of the fuse panel inside the car. Access is from the drivers side kick panel
Inside left (drivers side) door on dash board under an access panel...
follow the coolant hose that runs from the top right (drivers side) of the radiator and you will see it attaches to the engine via a black plastic adapter. the front of this adapter has a brown, a blue, and a yellow electrical connectors attached, you need to remove all hoses attached to the black plastic device to get a better view but the thermostat is inside this plastic assembly.easier to access if you remove the plastic motor covering and spark plug wire holders.
inside drivers fender pop hood remove plastic i think 3 bolts hold it to fender
On the inside of the rear quarter-panel drivers side, access through trunk
In the drivers footwell , by the inside hood release , behind the kick panel ( there is an access hole )
You must pull off the plastic panel from the inside of the truck to access the lights.