Nissan Maxima
Nissan Pathfinder
Toyota 4Runner

How do you remove the power antenna motor and antenna from a 1998 4Runner Once this is done is it possible to install a euro style antenna?

373839

Top Answer
User Avatar
Wiki User
Answered
2006-03-28 22:46:36
2006-03-28 22:46:36

I have a 98 4runner limited and It has a power antenna, I recently replaced the mast for it and it's pretty easy to replace the antenna it self. not sure about the euro ,but I know that it's pretty easy to take off the motor (if you can get under the panel) and just replace it with a normal antenna

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


you have to remove the fender

Remove the old antenna. Attach the universal antenna to the radio and replace the radio after finishing the task. Install the new antenna. Test to ensure the wiring works.

Remove the wiring harness from the and of your 1997 Chevy Lumina antenna. Remove the antenna retaining nuts. Reverse the process to install the new antenna.

You can replace your 2003 Toyota Echo antenna. Remove the antenna retaining nut. Remove the cable from the bottom of the antenna. Reverse the process to install the new antenna.

No. If your wheel well has trim, you must remove that. Then remove the bolts that mount the fenderwell to the fender (this is not easy). This allows the fenderwell to be pulled back giving you clear access to the power antenna motor. Note that if the antenna is broken or doesn't go up and down anymore, you may be able to fix it by purchasing just a replacement antenna from Toyota. Typically the toothed cable breaks and all that is required is to remove the motor, disassemble the spool holder ( to remove the broken cable) and then install a new antenna.

Begin by removing the antenna cable from the bottom of your 2003 Pontiac antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.

Remove the wiring harness from the bottom of your 1987 Chevy Corvette power antenna. Remove the power antenna retaining nuts. Reverse the process to install your new power antenna.

Remove the wiring harness from the bottom of your 1996 Mercury Cougar automatic antenna. Remove the retaining nuts at the bottom of the antenna. Reverse the process to install your new automatic antenna.

Begin by removing the wiring harness from your Volvo antenna. Remove the antenna retaining nuts. The antenna will come off. Reverse the process to install your new antenna.

Remove the wiring harness from the bottom of your 1987 Buick Regal power antenna. Remove the power antenna retaining nuts. The power antenna will come off. Reverse the process to install the new power antenna.

Begin by removing the wiring harness from the bottom of your antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.

Begin by removing the wiring harness from your 1992 Nissan antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.

Begin by removing the cable from the bottom of your 1997 Ford Taurus antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.

1) Pull the driver's side front wheel off. 2) Remove the wheelwell liner (may need to remove the fender flare to do this). 3) Remove antenna retaining hardware. 4) Remove radio head unit from dash to remove the antenna plug. 5) Pull antenna wire through firewall and dash and remove from car. Installation of new antenna is basically the reverse of removal.

You would need to get a tool to remove the notched chrome piece that holds the antenna mast, or carefully use pliers to unscrew it out. After you remove that, the antenna itself is held by a 10mm bolt. to get to it you'll need to open up the trunk lining near the antenna location and remove that bolt. Then, pull the antenna far enough to disconnect the antenna wire and power. Assuming the antenna motor is still functional, you can then replace the antenna mast with a new one. Or, you can install an aftermarket rubber antenna.

trying to install a new antenna cable, from outside the truck to the radio, how do i do this

how do I remove the climate control from a 1999 toyota 4runner

Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.

remove the nut at the base of the antenna. Slide off the grommet. The antenna will drop os hold on the the antenna as you remove the nut and grommet. Once this is removed. You will see how to remove the antenna unit.

The 2000 Elantra's are equipped with a fixed antenna * Use a wrench on hex portion of the antenna mast to remove the exterior antenna * Remove the antenna base is acced by removing the interior trim panel * Disconnect the antenna lead from the base of the antenna and remove the mounting bolt

you are going to have to pull the plastic inner fender well on the passenger side, then you should be able to reach up from the bottom & unscrew nut holding old antenna & remove. repeat process in reverse to install.

Remove the plastic cover from inside the wheel well to expose the antenna. Remove mounting bolt. To replace antenna purchase an antenna with an adapter. Cut old antenna wire at base and connect new antenna using the adapter.

Remove the 1994 be a week Century radio decorative cover. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness and the antenna cable from the back of the radio. Reverse the process to install the new radio.

how do i remove an antenna to a 1998 chevy express 1500 van


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.