0
How do you remove the pulley on the steering pum p on a 2001 sierra?
Wiki User
∙ 14y ago
You need to rent, borrow or purchase a Power Steering pulley puller. This tool will remove and replace the pulley without damage to the pulley or the pump.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove the power steering pump on a 2001 Monte Carlo?
Start by removing the lines, drain the fluids, then remove the pump pulley. After that, remove the mounting bolts.
How do you replace the power steering pump on a 2001 gmc Yukon?
Remove the belt from the pump. Disconnect the lines and drain the fluid into a container. Unbolt and remove the pump. Using a puller, remove the pulley from the power steering pump. Mount the pulley to the new pump. Reverse procedure to install.
How do you remove pulley from power steering pump on 2001 Dodge Dakota?
It takes a special tool that you may be able to rent from a part store.
How do you remove the steering wheel on a 2001 Chevy Tahoe?
How to remove steering wheel on a 2001 chevy tohoe
How do you remove the cover to a 2001 Chevy Blazer Steering wheel column?
How to Remove the Steering wheel From a Chevy Blazer 2001
Where is the tensioner pulley or idler pulley on a 2001 Dodge Dakota Sport 2.5L 4-Cyl I am trying to change the serpentine belt?
Standing in front of truck look to your below power steering pump you see a pulley that is your tenisorner pulley 15mm loosing the bolt on pulley above to the left is another 15mm also turn counter clock wise to loosen it this will help remove the belt
How to replace the tensioner pulley on a 2001 galant gtz?
Remove air box, pulley is located just under attached to engine block. Should remove bolts take off belt, and replace pulley and belt.
How do you remove harmonic balancer off 2001 Ford Focus?
You need a pulley puller.
How do you remove the front seat of a 2001 sierra?
Should be bolts at each corner of seat
How do you replace the idler pulley on a 2001 zx2?
Remove serpentine belt. Unbolt old pulley. Install new one & serpentine belt.
How do I remove the horn cover on a 2001 Ford Ranger steering wheel?
screws on the back side of the steering wheel
How do you change idler pulley on 2001 Monte Carlo?
You can change an idler pulley on a 2001 Monte Carlo by first, removing the negative cable from the battery. Using a socket wrench, loosen the tension adjustment bolt. Slide the serpentine belt away from the pulley. Remove?æthe center bolt, and remove the pulley from the engine. Replace the pulley,?æreturn and tighten the bolts, and replace the serpentine belt.
