on the driver side on top of differential hub
APX 2.4 Quarts
how to remove rear seat from 1998 mercury villager
Remove driveshaft, remove pinion nut, remove rear cover, remove axles, remove differential. Push pinion out through housing.
A Ram 1500 has a Dana 44 front and a Chrysler 9.25 rear. A 2500/3500 has a Dana 60 front. A 2500 V8 would have a Dana 60 rear. A Diesel or V10 would have a Dana 70 or 80 rear.
How do you remove the rear drum brakes on a 1998 ford escort
You have to remove the diff assembly
Not normally, but it was an option.
200 ft pounds
You have to remove the rear seat and rear side pannels first, then you can pull off the rear deck.
to change carrier bearings in rear differenial you have to remove the rear differential from the vehicle. then remove the cover. remove the bearing caps. remove differential carrier unit. remove bearings. install new bearings. and then reassemble. recommend having a professional repair shop peform repairs
how do you remove the right rear axle on a 1998 ford expedition?
The Chevrolet 3500 rear radio panels are held in place with retaining clips. There will be a retaining clip on the top and the bottom of each panel. Pry outward on each retaining clip to remove the panel.
For a permanent "fix" you could remove the driveshaft leading to the rear wheel differential.
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
3 quarts per axle
On a 1998 Ford Explorer ( same as my 1995 ) Ford calls the smallrear shock absorber that runs on an angle the ( rear axle differential shock absorberor lateral shock ) As far as I can figure it is used to stabilize the rear differential ( P.S. I'm not a mechanic / technician )
remove rear cover from differential, find 1/4 inch bolt in the third member that holds the 1 inch diameter pin between the axles. Remove the bolt and the pin, push the axle that you want to remove in towards the differential and remove the C-clip that keeps the axle in the differential. Pull the axle, using a bearing puller remove the oil seal and the bearing. Replace the bearing and the oil seal, make sure it is installed in the right direction or it will leak. install the axle, C-clip, pin, bolt, rear cover, and differential oil.
All Ford Rangers have a rear differential , and if they are 4X4 equipped , a front differential also
to change a rear wheel seal on a GMC 3500 you need a 7/16 wrench, hammer and cold chisel, 32mm socket and ratchet, and flat blade screwdriver. Remove bolts to remove drive shaft. Next, remove old seal and replace with new seal.
You will have to remove the rear end plate. NEUTZ
The sensor on a 1998 Ford F150 4x2 is on the rear differential. The 1998 was rear wheel ABS only so don't bother looking for any front sensors.
The rear differential pertains to a motor vehicle and means the differential that is situated in the final drive of the transmission assembly, found in rear-wheel drive vehicles.