0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove a pulley with out a pulley puller?
If you pry up on the pulley with a bar on each side of it and while keeping pressure on the pulley, hit the end of the shaft that the pulley is on with a brass mallet, the pulley will usually break free.
How do you replace the rear end on a 1999 Mustang?
Remove wheels Remove brake lines Remove driveshaft Support rear end at axles Loosen and remove springs "U" Bolts
How do you change drive belt on mtd riding mower mod 13ax675g062 ser 1d309c30054?
which one? there are two belts. take off the shift knob and access panel (two screws) remove clip on the varispeed pulley and pull up and remove the top belt which is the rear one and then you can also remove the bottom belt which is the front one, then to remove front belt you will have to first remove deck belt at the engine pulley and then remove the pulley to drop it down so you can remove the front drive belt. the installation is the reverse. the rear belt is kinda harder to install, just get it started on the rear pulley and walk it on, it is sometimes easier to remove the battery and the insert to get at it better. sometimes you will have to do some adjustments but not always. Get the manual somewhere on the web which will tell how to change belt and adjust as necessary.
Replace rear wheel bearing on 2002 Mercury Mountaineer?
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
How do you remove a stripped plug from the rear end?
kill your self
How do you remove the crankshaft pulley on a 1998 Toyota tacoma with the 2.7 engine?
how to replace the rear bearings on a 1999 Honda fourtrax ATV
What is the size of the Rear pulley for 2008 Electra glide classic?
How teeth on rear pulley 2008 electra glide
How do you remove the power steering pulley from a 1996 Pontiac Bonneville?
There is a specific tool for this operation. It is a power steering pump pulley puller. This grabs the groove in the end of the pulley and pushes the punp shaft away from the pulley. Available at your parts store.
How do you remove the crank pulley on Mitsubishi 3.0 v-6?
remove all belts,tensioners etc, remove pulley bolt, use HARMONIC BALENCER PULLEY to remove - DO NOT USE NORMAL PULLEY REMOVER - must be pulled from center of pulley not from outer edge
Where is the crankshaft seal on 1988 dodge caravan?
There is one on each end of the crankshaft. The front main seal is at the pulley and, while the rear main is at the transmission end.
How do you remove a rear hub assembly on a 97 avenger?
Remove the tire and wheel. Remove the brake assembly and rotor. Remove the axle end cap. The rear hub assembly will come off.
How do you remove a pulley?
i have a 1998 grand cherokie 5.9 how do i remove the pulley what tool do i use
