0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How To Remove Arm Lifts 1991 Escort Wagon?
Make sure you have a friend support the back hatch while you take off the supports. They are bolted on. Do this because the hatch is quite heavy without the lifting arms.
How many kws does a 1991 2L subaru legacy gt station wagon have?
OVER 9000!
Is it possible to syphon gas from a 1991 subaru loyale?
Yes, if you get into the trunk or back of the station wagon, you have to find the plate that is held with on phillips screw. Remove that plate, then you will see five 8mm bolts. Remove them and pull the fuel gauge sending unit out enough to get your hose in there. Syphon away.
How do you change the brake light bulb on a 1991 accord wagon What panels need to be removed and how do you remove them?
you must remove every panel on the car... you can remove them with your little mexi-pee pee
When was The Wagon - song - created?
The Wagon - song - was created in 1991.
When was Subaru Alcyone SVX created?
Subaru Alcyone SVX was created in 1991.
Where is the water pump on a 1991 Subaru legacy?
The water pump on a 1991 Subaru Legacy is in the engine compartment. It is found at the base of the engine.
How do you replace the Fuel injectors on a Subaru?
how do you replace the fuel injectors on a 1991 subaru legacy
How to replace ecu on 1991 legacy l wagon 5 sp?
How do you replace the Catalytic converter on a 1991 Suburu Legacy L station wagon? Where I get the used parts?
What year fronts seats in 1991 Subaru Legacy are interchangeable?
In general, many of the 1990 through 1993 parts are interchangeable on the Subaru Legacys. But your best source would be a 1991 Subaru Legacy, followed by a 1990 Subaru Legacy. Verify the bolt patters before purchasing from 1992 or 1993.
How do you clean a 1991 Subaru legacy fuel injector?
Aircompresser
What could cause water to leak inside the trunk of a 1991 Chevy Camaro?
Rear hatch leaking on 3rd gen Camaro,Z28-IRoc-z/Trans Am/Firebird-GTA The seal between the window and the hatch is worn. Any glass shop will reseal this.to do yourself buy a glass sealer or tar. remove inner hatch cover, there are I believe 4 bolts holding the window to the hatch. remove them. Have a large 4by4 holding up the hatch. Remove the hatch struts. Clean off old sealer under window an hatch. Reseal the hatch/window. Put the struts back and retighten all the bolts snug not too tight. I have had the same problem. This will fix ur water leak problem..
