Want this question answered?
The first step to remove the seat of you Honda Steed 400 vlx is to remove the fuel tank. The fender struts have a tab the fits to a bracket on the seat. There are bolts and screws on each side that can the removed and you can lift off the seat back first then slide the tab out from the front. You may need to unloosen the fender stuts to allow for some wiggle rom with the tabs or alignment. The Struts are 12mm. If it is bolted in from the back of the rack. Remove the rear cover.
its quite simple just remove your seat and fairing and almost directly below where the seat is your battery is sitting upright. just disconnect the cables and pull it out.how do you remove the seat on a vfr 400
I have an 08 Burgman 400.For mine it is located underneath the bike in front of the rear tire. You'll find it behind a plastic hinged cover. The tool for the adjuster is located with the tool pouch in the compartment under the seat.
disconnted battery first or air bag will open . disconnect wires then bolts and remove. Replace in reverse
pull the back leaver forward and slowly lift with 10 people
This is a simple procedure on most quads; I will use my Kawasaki Prairie 400 as an example. The battery on this ATV is located under the seat; first thing is to pull the seat release located at the rear of the machine under the back fender. Once the release has been pulled the seat is free to be removed. After setting the seat aside the battery is right there. The battery will be held in its compartment with a strap. I remove the strapping, then remove the cables starting with the negative and then the positive cable. The battery is free to be removed from the four-wheeler. Good Luck!
It's in the gas tank 1. You have to pop out the bottom rear seat (pull up about 4 inches from the seat edge) 2. Remove the bolts holding the rear back support 3. Slide the rear back support up and remove 4. There is a flap in the center that you flip up and you will find a circular plate 5. Remove plate with a scraper or screwdriver 6. There will be another plate with 8 Phillips screws to be removed 7. You will next find the fuel pump inside the fuel tank attached by 3 nuts Note- disconnect the battery at least 90 seconds before starting work near the gas tank.
it should be under the driver's seat
There are two. Just remove the two phillip screws on the side that is blown and change the bulb.
The cast of B 400 - 1997 includes: Tahir Haroun Herve Tostivint
what other axle will fit a 94 kodiak 400 rear
I have a 1969 Firebird comanche with pw/pt/pa/tilt/cruise/pwr disc brakes/safetrack rear end/fold down rear seat/leather interior/ac/vanity mirrors/ 400 ram air