Chevy Blazer
Chevy Blazer S-10
Ford Expedition XLT

How do you remove the rear side panels of a 2 door 2000 Chevy Blazer?


Top Answer
User Avatar
Wiki User
2005-09-15 05:13:02
2005-09-15 05:13:02

The rear panels are heald in plase by clips. all you have to do is take the O SHT handles the coat hangar hooks and seat belt bolts also remove the trim from the pass, driver, and tailgate sill, as well as pop off the corners of the trim peace from the top of the tailgate opening. You also want to open the side windows to get the panel around the latches but It's still bit of a pane getting the pannel around the window latches. There is one screw That I forgot to mention at the rear of the drivers side panel it is where the jack is. The pannels are hard to pull off because of the metal clips but they come off.

User Avatar

Related Questions

I have a Chevy Blazer 2000 4 Wheel Drive ZR2 The Spare Is On The Back With a Lock How do I remove the Spare Tire Thank You

i just recently put new door speakers in a 2000 Chevy blazer. They are 6 and 1/2 in all four doors.

How do you set the timing on a 2000 Chevy blazer (V6)

An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.

Yes, a 2000 GMC Jimmy hood is compatible to a 2000 Chevy Blazer. This is only on the S10 Blazer though.

Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck

how do you replace seatbelt retractor on a 2000 chevy blazer

The 2000 Chevy Trail Blazer doesn't have a timing belt.

NO it will not. They are complete DIFFERENT designs. Will NOT interchange.

Your 2000 Chevy Blazer air-conditioning bracket is held in place with for retaining bolts. Remove the retaining bolts with a 9/16 socket. The air-conditioning bracket will come off.

the 1996 and 1997 are the same and would not work in your 2000 straight from GM

A 2000 Chevy Blazer is a GM vehicle. Vehicles made by GM do not come equipped with an inertia switch.

Mine is 19 gallons Chevy Blazer SS 4.3

Yes, the distributor has to come out to remove the intake manifold in order to remove the heads.

You will need to drain the fuel from your 2000 Chevrolet Blazer fuel tank. Remove the fuel line from the fuel tank. Remove the fuel filter retaining plate. Remove the fuel filter. Reverse the process to install the new fuel filter.

The turn signal flasher on a 2000 Chevy Blazer is located under the dash. It is just above the gas pedal and slightly to the right.

To replace an ignition switch on a 2000 Chevy Blazer remove the lower steering column and dash. Locate the ignition switch and pull the end-clip off the main harness. Remove the mounting screws from the ignition cylinder and replace the unit.

How to remove steering wheel on Chevy lumina 2000

I would like to know if my 2002 chevy blazer with a stock 4.3 vortec pull 2000 lbs ?

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.