answersLogoWhite

0


Best Answer

remove access plate on floor around shifter, 4 bolts hold the shifter onto the trans.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the shifter arm from the transmission on a 94 jeep wrangler?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

On a 1990 jeep wrangler the shifter is in neutral but the transmission is stuck in reverseit s a 5 speed?

You may have to remove the shifter and realign forks in the top of transmission--problem usually caused by wear


How do you remove a 97 jeep wrangler transmission?

unbolt it =]


Slave cylinder jeep wrangler 87 how to replace?

Yo have to remove the transmission.


How do you change the transmission fluid on a 1999 jeep wrangler with a automatic transmission?

You have to remove the pan if there is no drain plug


How do you remove manual transmission on a 1992 jeep wrangler after all bolts are removed?

disconnect clutch, disconnect drive shaft, remove trans brace, and slide transmission back and out of the flywheel being careful not to tilt it until it is free. you may need to remove the shifter to get enough room to slide it back.


How do you remove the doors from a 2004 Jeep Wrangler?

how do you remove the doors from a 2004 jeep wrangler


89 jeep wrangler transmission gets stuck in 1st gear?

check your shifter bushings, next would be inside the trans at the shift collar.


What does it cost to replace a 2005 jeep wrangler transmission?

To edit original question....Jeep Wrangler 2005 manual transmission


Where is the computer on a 1998 Jeep Wrangler?

Bolted to the floor in front of the shifter.


Jeep Wrangler shifter handle?

more specific please. shifter handles should just unscrew.


How do you remove the shifter knob on a 1995 Jeep Wrangler TJ?

Loosen the Jam nut on the bottom of the know CW and then turn the knob CCW..


How do you remove the whole shifter from manual transmission on a 1995 jeep wrangler?

Remove the access plate on the floor to expose the trans. disconnect the transfer case shifter as 2 of it's bolts are shared with the shifter on the trans. The bracket is held on to the 2 left hand shifter bolts and will have nuts on the top to remove, it is not possible to just move it out of the way without removing the other 2 bracket bolts further down on the trans. Then remove the 4 retaining bolts on the top of the shifter and pull it out.