star by taking off the side door panels then take of the corner panel then remove a 1/2 srew and there its off star by taking off the side door panels then take of the corner panel then remove a 1/2 srew and there its off
You will need to remove the inside door panel of your 2002 VW Jetta. Remove the wiring harness from the mirror. Remove the side view mirror retaining bolts. Reverse the process to install the new side view mirror.
Remove the inside door panel of your Chevrolet Astro Van. Remove the wiring harness from the mirror. Remove the side mirror retaining bolts.
You have to remove the complete mirror from the car. Remove the nuts from the inside.
Mirror fixIf you look on the lower side of mirror there is a small hole/opening and a small straight blade screw that lossens the mirror from the housing. Undo the screw, remove mirror glass assembly and you will see mirror glass brackets that open & release glass
the mirror should just pop out, remove the two heating wires and install the new mirror
Your local auto glass shop will have a replacement glass that goes on with double sided tape, it even has the "objects are closer" on it. You just carefully remove the old glass and stick on the new glass
If it is on the door, you have to remove the door trim pad. The guy who said that ^^ didn't read your question. You asked about the rear view mirror, not the driver-side mirror or passenger-side mirror. As for your answer, I have been trying to find out for myself. What I have found so far is that you rotate the mirror about 90 degrees to either side and it should pop off. Do NOT pull or push very hard because you risk cracking or breaking your windshield. I .
you can remove the old glass and simply silicon glue the glass replacement in. Cost of mirror is 10 to 12 dollars. Takes 15 minutes
if you made one side of mirror opaque,other side will become a mirror.
Go to the following website. It will show how to remove the side mirror. kwmuth.com The above website has installation instructions for signal mirrors, complete with pictures and step-by-step instructions. Briefly, however, the mirror glass is held to the motor plate by four plastic tabs. To remove the mirror glass, push on the bottom of the glass to move the bottom into the mirror housing and allow the top of the glass to clear the housing. Slip your fingers under the bottom of the glass and pull upward to snap the glass off of the tabs. To install the new mirror glass, align the slots on the back of the new glass with the tabs on the motor plate. Push downward until the glass snaps into place.
ON MY 2003 JETTA YOUPUSH IN ON ONE SIDE AND SIDE TO TAKE OUT. BE CAREFUL AND DON'T BREAK THEM.
Remove the inside door panel of your Chevy Cavalier. Remove the drivers side mirror wiring harness, if the mirror is electric. Remove the drivers side mirror retaining bolts. Reverse the process to install the new drivers side mirror.