You have to remove the whole lower panel of the dash with either Alan or torch wrench.
how do you remove the stock radio on a 1996 lexue es300
Begin by removing the decorative radio retaining cover. Remove the radio retaining screws. Slide the radio out, remove the wiring harness and the antenna cable from the back of the radio.
you cant you cant
Try www.streetdreams.com
* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard
im trying to find out the same thing
The stock radio on a 2008 Ford F550 is removed by removing the trim and cover panels, disconnecting the wiring harness, and taking out the retaining screws. The radio can then be slid out of its housing and removed.
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio.-Shocker
Remove Stock Ford RadioCheck related link below
how do you remove the stock radio from a 2000 ford focus zx3 Go to walmart in the car stereo section. In there, there are these packs of 2 U-shaped metal rods. If you buy theses, stick them in the correct holes in the radio then it will pop right out.
remove the exterior trim peace that surrounds the outer edges of the radio. Then there should be either two 10mm bolts or four phillip head screws holding the radio in place remove them and gently remove the radio from it slot and then unplug the wire harnesses and antenna in the back of the radio. repeat in reverse to reinstall.
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio. and that should do it-Shocker
The ticker symbol for Delta Air Lines is DAL and it is traded on the New York Stock Exchange.
first don't remove your stock stereo if u havn"t already. The radio works with the carscomputer to reset codes and other stuff. you can get an adapter that turns your speaker wire on the back of the radio into left and right channel to hook up to an aftermarket amplifier. then hook up your new speakers and sub woofer to the amp and use the stock radio to get your grove on. or install an after market radio in the glove box or middle console but don't remove the stock radio. get rid of the stock amp not powerful enough.
Remove ashtray by lifting up & out. You will see 2 Phillips head screws. Take them out. Remove ashtray bracket assembly. You will see 2 clips on the bottom of radio on both sides press both tabs down & pull out radio.
First you must remove the climate control knobs, then unsnap the cover panel with a screwdriver. Remove the two screw behind the panel and from behind the drink holder. Unsnap the plastic frame from the radio and lift it up to remove. Then remove 4 more screws fro the radio and it will slide out.
my 88 2.0 si radio was bolted in from the back and sides. start taking apart the console and get behind it to unbolt it
if your asking if you can put subwoofers on the stock radio then no you have to have an aftermarket radio
According to my brother (who is a mechanic), The stock stereo in the protege requires radio removal tools (2 sets) to remove -- you can get them at just about any parts store. Just carefully remove the molding around the radio, insert the tools all the way and then pull them outward to release the clips. The radio should just slide out.
you have to putt the dash apart starting with the shifter knob, have fun.
Heres a supersecret account it can superchat name:blueysk9 password:24356
Still need an answer? Remove plastic dash cover, radio itself should have 2 spring tabs on the right and left side, not the top, you must push all these tabs in and pull radio out. help@bobwyman.com
First thing is to remove the surround from the auto/stick shift, then unscrew the ac/heat control panel, then unscrew the top bzel from that panel to get that off and you will see the mounting screws for the radio
You have to remove the air vents/hazard lights/defrost button with a screwdriver and then there are 2 bolts that you take out above the radio and that's it.
stock oem or after market radio all radios have diff. keys. but you can remove the whole thing by pulling the plastic bezzel around the radio, pop. then you see all the screws. remove them and out it comes. remove ash tray and its holder see more screws.