0
How do you remove the top heater hose on 1996 grnd caravan 3.3 bottom end going to water pump housing?
Wiki User
∙ 15y ago
You must remove the bolt holding the spark plug clip and wiring just above the water pump housing, and move the wires out of the way as much as possible. The hose is held to the housing by a squeezable clip - need long preferably curved needle nose pliers to squeeze and pull off hose.
If no room, you are gonna have to take off the AC unit so you can get down there.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you fit lada niva heater motor?
Remove the center switch console. remove the 4 spring clips holding the square heater motor housing and remove the housing. Inside the heater motor housing Remove the two spring clips holding the heater motor in Remove wiring connections and then remove the heater motor. Install new heater motor and installation is in the reverse order of above.
How hard to install heater core on 2001 dodge 3500 w cummins?
Remove the heater-A/C housing from the vehicle. Refer to Housing Assembly HVAC/ Service and Repair/ Procedures. Remove the screws and retainers that secure the heater core to the heater-A/C housing. Lift the heater core straight up and out of the heater-A/C housing. INSTALLATION Lower the heater core into the heater-A/C housing. Position the retainers over the heater core tubes. Install and tighten the screws that secure the heater core and retainers to the heater-A/C housing. Tighten the screws to 2.2 Nm (20 in. lbs.) . Reinstall the heater-A/C housing in the vehicle Refer to Housing Assembly HVAC/ Service and Repair/ Procedures.
Instructions on how to remove a heater core for a 1999 Jeep Wrangler?
You will be better off if you buy a service manual or borrow one from a library. You have to drain the freon, remove the entire dash, remove the heater/ac housing, and dissassemble the housing to access the heater core.
How do you change the heater core on a 1990 Chevy Silverado?
Step 1: Disconnect heater hoses from under the hood Step 2: Remove the (6) 9/32" screws securing the heater box cover to the bottom of the heater box. Note: (2) of them are hidden so make sure you get them all. Step 3: Remove the heater box cover. Step 4: Locate the (1) 9/32" screw that holds the heater core to the housing. Step 5: Gently pull the heater core from the housing and remove. Installation is the reverse of disassembly.
How difficult is it to remove a heater core from a 1995 Dodge Caravan and approximately how long will it take?
it takes about 6.5 hours round trip you need to remove the dash to remove the heater box
How do you change the heater core in a 1992 ford explorer V6 4.0L?
Open and empty the glove compartment , press in on both sides of the glove compartment at the top and pivot it down , remove the 2 hinge screws and the glove compartment. on the heater housing , remove the 4 screws on the bottom , then slide down the bottom of the housing , there is the core, the only thing holding it in now are the heater hoses. loosen the hose clamps and remove the hoses , then reverse the process to install the new core, it shouldn't take more than 90 minutes.
How do you get to the heater core on a Ram 1500?
You have to remove the dash and HVAC housing.
How do you replace a heater core on a 1987 jeep wrangler?
When engine is cold of course, drain your coolant, Disconnect the negative battery cable, remove the heater hoses at firewall, disconnect the operating cables from the heater vent housing under dash, and disconnect the defroster duct. Now under the hood again, disconnect the wire from the blower motor, and remove the nuts that hold the heater housing to the firewall. Then under dash, remove the heater housing by tilting it downwards to clear the defroster duct, and back towards passenger seat. Remove the housing cover from the firewall side of the housing and remove the heater core. Clean the housing and install new heater core and assemble in the reverse of dis-assembly. Don't forget to put coolant back in after it is back together!
How do you get to the heater core on a 1985 Buick Regal?
To get to the heater core, first remove all electrical connectors from heather housing under the hood. Next remove the chrome trim piece at the bottom of the windshield. Remove the two aluminum brackets mounted to the firewall used to hold the chrome trim piece with the speed nuts. Then remove the top screen portion of the heater housing, followed by all the bolts/screws for the top half of the housing. Using a large flat screwdriver or prybar, separate the upper half from the lower half of the housing, and from the firewall. Note, the wiper arm and bracket may need to be moved to gain access to certain screws/bolts, and for clearance when removing the upper half of the heater housing. The heator core will now be exposed. Remove the screw securing the ground clip and bracket holding the heater core down. remove the two heater lines attached to the heater core, and pull the heater core up and out of it's place. Before installing a new heater core, clean out any coolant and/or other debris from the heater housing. Installation is same as removal in reverse order, except the upper and lower halfs of the heater housing need to be sealed upon reassembly. Fairly easy job, just takes a bit of patience.
How do I change headlight on 2005 Dodge Grand Caravan?
You must remove the 3 bolts on the opper part of the headlight housing and then remove the entire housing. You can then reach the bulb connection
How do you remove oil filter on 2007 vw jetta?
The filter is in a filter housing. Remove the plug in the bottom of the housing. The filter housing is then loosened using a specific wrench for that housing type.
How do you replace heater core in 2000 crown Victoria?
How to remove the heat core housing on a 2001 crown Victoria? I remove the dashboard, can't get heat core housing out.
