Best Answer

need a puller, 3bolt puller go to autozone

User Avatar

Wiki User

โˆ™ 2007-10-16 02:27:24
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you remove the vibration damper harmonic Pulley from a 1995 buick regal 3800?
Write your answer...
Still have questions?
magnify glass
Related questions

How do you change Aerostar harmonic balancer?

Start by disconnecting the negative battery cable at the battery. Remove the radiator. Remove the drive belts and crankshaft pulley. Remove the Vibration Damper (Harmonic Balancer) bolt. Use a puller and remove the Vibration Damper. Reverse these instructions to reassemble. (Tighten the Vibration Damper bolt to the correct torque)

How do you replace the crankshaft pulley on a 1991 Chevy S-10 4.3L?

Disconnect the battery and remove the fan assembly and crankshaft belts. Remove the center bolt from the pulley and use a crankshaft pulley remover to pull off the pulley. You can usually borrow one from an auto parts store.

What puller is used to remove crankshaft pulley?

Depends on what type of vibration damper (crankshaft pulley) you have. Your local auto parts store probably has the one you need and can rent it to you.

How to remove crank pulley?

On most newer cars, the crank pulley is one piece with the harmonic balancer.... Remove it with a harmonic balancer puller.

How do you remove the vibration damper pulley for ford escort 1.9 1994?

The vibration damper pulley and the crankshaft pulley are pressed together with a rubber sleeve. They are held onto the crank by a key and keyway. I've never had to use a puller. Usually when you take the bolt out of the crank it will just wiggle off. I've never had one on their that tight that it wouldn't come off just with my hands.

How do you remove damper pulley on 91 Saturn SL?

Just remove the bolt holding it on.

How do you remove the vibration damper on an ht4100 Cadillac?

rent a puller rent a puller

How do you remove a 1957 Chevy small block 283 damper?

with a damper or harmonic balancer puller found at your local auto store

How do you remove a crankshaft pulley on a 67 Chevelle?

The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.

How do you remove a harmonic balancer on a 99 Chevy Monte Carlo?

take off the serpentine belt and crank pulley and you will need a harmonic balancer pulley to get it off.

How do you change the crankshaft vibration damper on a 1993 Jeep Cherokee Sport?

do you mean the harmonic remove you need to remove the fan and shroud assembly. YOu may need to remove the radiator to get enough room to get a impact gun and a socket on the nut to remove the harmonic balancer if you dont have a impact you are going to have to lock the engine and get a large breaker bar and a socket on the nut and then remove the part.

How do you replace crankshaft sensor on 2001 s10 blazer?

Locate the crank sensor behind the vibration damper (crankshaft pulley). Unplug the wire harness connected to it. Remove the small bolt holding the sensor in place. Remove the sensor.

People also asked