Although I don't own that kind of car, there are really only three ways these handles are put on:a screw that you can see, a spring clip or a "pin" that is covered by the upholstry. You'll need a putty knife to move back the cardboard backed upholstry to see it ,,but its there.(sometimes its a screw) but don't give up,,,its there.
There is a good description at the following page: http://neons.org/howtos/door/
Most window handles are either held on with a screw or a clip. Your has a clip and you need a window handle removal tool to get the clip off. They are inexpensive and most auto parts stores sell them.
Pull out the U-clip located on the base of the window crank.
Click on the link to your right for instructions.
push in on the door pannel by the crank and remove the snap ring behind the pivit point
how to remove a door lock cylinder on 2000 dodge neon
Their is a special tool to remove manual crank window cranks and it will work for almost any car. You can pick one up at auto zone
You remove heater core in doge neon by smashing the windows then taking off the doors so you can get th the heater core then you get a crowbar and rip it out (if this destroys your dodge neon then your car isn't a real dodge neon).
If you use a towel or rag to get behind the crank and run it back it forth it will pop the clip lose so you can remove it.
Can you show me pictures on a dodge neon 1998 on how to remove and replace a front axle.
It has no governor, that you can remove. you can get your computer reprogramed
Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036
Because nobody could handle it's untamed awesomness.
A Dodge Neon does not have a distributor.A Dodge Neon does not have a distributor.
Remove the fuel tank
You can not. You have to remove the filler tube and drain from there.
You take it out
remove the clip retaining crank to the regulator shaft, this requires a special tool available at most parts houses.
actually there is also a Plymouth neon as well as the dodge neon their pretty identical an the parts are the same
The 2000 Dodge Neon computer is behind the kick plate on the passenger side of the passenger compartment. Remove the kick plate. Remove the computer retaining bolts. Remove the computer wiring harness.
The dodge neon 1995 parts are compatible with dodge neon 1999
i just bought a dodge neon 2 days ago and i love it i just wish i could install an alarm system and power window motor. i have no idea i hope someone can answer soon
Which speakers and which moulding exactly are you refering to? If you are talking about the door speakers: Just remove the screws on the panel and inside of the door handle and inside of the armrest on the door there is a screw. Then you must remove the door handle by using a screwdriver to pry off the clip behind the door handle. After that just pop the panel off.
try this one: Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036