what yoiu need to do is get where you can get behind the switch and feel for a little button on the flat side of the switch. You will need to push that switch and pull out the knob at the same time it is not the easiest thing to do but if you work at it it can be done.
Begin by removing the tire and wheel from your 1999 Dodge Adventure. Remove the end of the axle. Remove the wheel bearing retaining nut. Remove the wheel bearing seal and remove the wheel bearing. Reverse the process to install your new wheel bearing.
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Sometimes it's on the left side of the wheel, sometimes on the right.
The windshield washer pump is located on the water reservoir. Remove the wheel on the driver's side and then the cowling around the wheel well that is in front of the wheel. Once it is off, the windshield washer pump on the water reservoir will be visible for easy replacement.
Remove the driver side front wheel then remove plastic skirting. Battery is on a shelf forward of wheel.
On the steering wheel by the airbag
Take out the shock. It unbolted at the ends. Remove the cotter pin and then the bolt from the upper control arm bearing. Use a pickle fork to separate it from the wheel. Remove the nuts on either end of the arm from inside the engine compartment. Tap the bolts through an remove from the wheel well side. A-arm should come out with maybe some help from a rubber mallet.
remove wheel, disconnect tie rod end, separate lower ball joint from control arm, remove axle nut, slide hub off axle, pull axle from transaxle housing
Remove the driver's side rear wheel; remove the inner fender well behind the wheel.
You'll find it under the nearside wheel arch. Best to remove the wheel before accessing it.
There are seven steps on how to remove a fender from a 95 Dodge Ram 1500. Some of the step-by-step instructions are remove the screws that hold the wheel well to the fender, remove the bolts from the wheel well fender, and then remove the bolts that attach the fender to the rocker panel flange.
I have a '99 Dodge Caravan, and the WW pump is located at the bottom of the WW tank. I presume it is the same on a '96. But the problem I have is that I do not know how to remove the WW tank (it leaks badly). Any suggestions? 1999 Dodge Gr. Caravan WW pump is at the bottom of the WW tank accessed by removing right front wheel and wheel well plastic liner 1966 likely same.