Want this question answered?
either tighten the valve cover bolts, or replace the gaskets.
i have an '02 xl-7 the rotors come right off
depending on which motor you have 2.0 in the valve cover 2.5 at the rear of the drivers valve cover
Remove the valve cover.....scrape off old gasket.....clean gasket surface on valve cover....apply gasket sealent to valve cover gasket surface.....set gasket in sealent.....reinstall valve cover.
let the engine cool down if hot,protection for eyes, proper tools, open hood remove screws,once apart clean off /remove old gasket ,clean both the cover/block.apply gasket maker high temp/oil resistant/then apply gasket carefully make sure it lines up properly then start to tighten down bolts not too tight at first leave room to adjust to fit /allign the bolts tighten to specific manufacture requirements.
i am going to change the valve cover gasket on my 97 cadillac catera, what do i need to remove and do? Is it hard?
how do i remove the valve cover to change the gasket in a toyota camry 1996
chang your gasket
you have to cut out the fuel cells because they are partially attached to the rocker cover gasket but that will not completely remove it you also have to remove the radiator and then the rocker cover gasket will be suspended in the air. You then have to cut the cords and the gasket will fall to the ground. And the rest is pretty simple.
remove right valve cover on cadilac sts
Remove the intake manifold retaining bolts on your 2003 Chevrolet Malibu. The manifold will come off. Remove the manifold gasket and clean the surface. Put the new manifold gasket on and reverse the process.
The valve cover ask it, on a S 40 Volvo, can be replaced by first removing the valve cover. Remove the old gasket and replace with a new gasket.