Check your alternator, that would be the main problem i think because the alternator charges your battery when in use, and with a bad alternator, means that your car is runnin soley off the battery and does not recharge the battery. Look into getting a new alternator. try testing the alternator at a local auto parts store, another test you could do is start the vehicle , and while it is running take off the battery cables, if motor turns off immediatly then your answer is that you have a bad alternator
battery hooked up backward, wires crossed somewhere or it could be the solenoid.
how do put belt on 1990 ford bronco 5.8
yup.
What is inside a battery ? Rocky_B - See my entry here for more things you might want to check: http://wiki.answers.com/Q/What_could_be_wrong_if_the_battery_light_stays_on_and_the_battery_still_runs_down_on_a_1996_windstar_after_installing_a_new_battery_and_alternator
I have a 1990 bronco 2, but i just had my starter rebuilt. it was relatively simple. its located underneath the engine. sort of close to the cab. but there are two bolts that connect it to the bronco. then there is a bolt that connects a wire to it. first disconnect you battery though
it is in the alternator
The map sensor on a 1990 Ford 5.8 EFI Bronco is on the passenger side. It is located on the firewall.
No
5000 lbs
The Bronco II was made till 1990. The it was replaced by the Explorer in 1991.
The Bronco 2 was sold between 1984 and 1990. The Ford Bronco 2 was a compact SUV. It was smaller than a full-sized Bronco. It was succeeded by Ford Explorer.
Hey Mike==It is on the back of the engine and you first remove the neg battery cable then the cables off of the starter then take the bolts out and workit out among the exharst . GoodluckJoe