answersLogoWhite
Ford Bronco
Ford Bronco Eddie Bauer
Ford Bronco II

Where is the starter on a 1990 Ford Bronco and how do you fix it?

878889

Top Answer
User Avatar
Wiki User
2011-09-13 11:12:31
2011-09-13 11:12:31

Hey Mike==It is on the back of the engine and you first remove the neg battery cable then the cables off of the starter then take the bolts out and workit out among the exharst . GoodluckJoe

1

Related Questions

User Avatar

The easiest way to fix a 1988 Ford Bronco gas hose leak is to replace the hose. You can also patch the week in the hose.

User Avatar

power steering fluid dumped out what caused this

User Avatar

you have to go to the car fix to remove it

User Avatar

what lights you talking about get a haynes or chiltons manual or take it to a repair shop

User Avatar

To repair the head gasket on a 1987 Ford Bronco, the head and the old gasket must be removed. Purchase a new head gasket and carefully install it according to manufacturer specifications.

User Avatar

Your starter has gone bad and will need to be replaced unless you can take the starter to an automotive electrician and he may be able to fix it.

User Avatar

The cost to fix a broken starter depends on the type of starter and where a person goes to fix it. It can range from $50 to $200 to fix a broken starter.

User Avatar

To fix an engine light code of 133 on a 1996 Ford Bronco with a 351 engine, the oxygen sensors need to be replaced. There are two oxygen sensors on this vehicle. One is on the driver's side and the other is on the passenger side of the exhaust or catalytic converter.

User Avatar

First replace the cheap part, the starter relay. It is attached to the short positive battery cable; clean cables too. If no luck and your battery is good, replace your starter with a remanufactured one; don't try to fix an old starter.

User Avatar

Make sure the relay is supplying the 12 volts to the starter - if so remove the starter and go get a rebuilt on to replace it or learn how to repair it yourself.

User Avatar

The sender is in the fuel tank and requires you to drop the tank as that is the only way to get to the hose and wires.

User Avatar

***Check the PCV valve. This can cause a vacuum leak which most likely your problem.***

User Avatar

1990 ford festiva dashboard light goes out when brake is applied and the instrutment guages some time don,t work what causes that

User Avatar

go to a shop and get a quote. every shop is different.

User Avatar

Don't bother trying to fix it, just get a replacement starter and put it in.

User Avatar

if starter is oil soaked. check oil sensor under dist on top oil filter housing. starter replacement required repair leak lift plastic cap on oil sensor while engine running if leaking you will see right away. warning oil my be hot use caution.

User Avatar

You cannot fix it, just replace it.

User Avatar

Try checking the cylanoid both on the starter and at the battery they maybe bad. I changed mine to and make sure it isn't shorted out and wired correctly

User Avatar

Replace the pick up coil it's inside the distributor. This may fix it.

User Avatar

You must remove the brake rotor or hub and punch out the broken bolt inwards, then press a new bolt in from the same direction.

User Avatar

No need to fix the starter, just goto NAPA or Autozone and get a remanufactured one.

User Avatar

If your starter is bad you simply replace it with another one.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.