Car Horns
Chevy G20
Mazda Protege

How do you repair a stuck horn on a 1991 Mazda Protege?

697071

Top Answer
User Avatar
Wiki User
2015-07-15 19:37:06
2015-07-15 19:37:06

Replace the horn relay.

Also look at the foam padding in the steering wheel,it may be worn out.

My 99 escort had a stuck horn...pull out the foam switch in front of the air bag, move it around a little, clean the contacts, then test it with a multimeter to make sure it un-stuck itself.

-Matt http://www.olszak.net

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Can someone please tell me how to hot wire the ignition of a 1991 mazda protege?

User Avatar

the clutch and the brakes share the same master cylinder on my 1991 protege dx 1.8 sohc

User Avatar

I/C regulator built inside alternator.

User Avatar

IF ITS A 1.8, THEN ITS NEXT TO THE TIMING COVER

User Avatar

6.5inches. Most modern speakers won't match up perfectly on the holes. I've owned a 1993 Mazda protege and a 1991 Mazda protege, I've changed the head unit, speakers and added an amp and sub to both, so I know =p

User Avatar

Front 5.25" @ 1.75" * Rear 5.25" @ Over 8"

User Avatar

The owners manual should have a fuse box diagram. If you don't have one, try MOTORLIT.COM

User Avatar

if you are standing on the passenger side facing the engine,it is on the lower left side.easy to change has two bolts

User Avatar

It's right there. you can't miss it, on the top right hand side of the engine block. did you look?

User Avatar

Check the fuse on the kick panel 25amp fuse

User Avatar

See if your public library has a Chilton's for your car to replace the clutch.

User Avatar

A bad battery terminal(s) connection, bad ground, bad ignition switch, bad starter.

User Avatar

in most cars, when your car dont go over about 30mph, its a trans problem.

User Avatar

It is illegal to repair brakes by an average person take the vehicle to a qualified person.

User Avatar

This is an NHTSA-listed Safety Recall item. All Mazda USA dealers are to perform this Safety Recall work free of charge for all 1990-1994 Mazda Proteges and 1990-1994 Mazda 323s, but only if indicated by either a malfuntioning driver- or passenger-side passive shoulder belt.

User Avatar

how do remove the brake drum on a 1991 mazda 323

User Avatar

Mazda Navajo was created in 1991.

User Avatar

well u could send me an email and tell me wat is wrong with your computer...Also what is wrong with your truck and why you want to trade for repair service.. wdt1969@yahoo.com dave

User Avatar

A standard 1991 Mazda 626 was originally equipped with 185/70-14 tires. A 1991 Mazda 626 Turbo came originally equipped with 195/60-15 tires.

User Avatar

It is important to know as much as possible about the car that it is driven. Yes, there is a clutch adjustment on a 1991 Mazda 929.?รฆ

User Avatar

It would appear that the horn button (on top of the steering wheel) is stuck. Beat on it with you fist to see if that stops it. If it doesn't, you're going to have to pop the horn button off. Analyze and repair the problem. You can disconnect the power source from the horn to make it stop. On the back of the horn itself(if you can find it under your hood) there is a wire that supplies the electric power, disconnect this wire.

User Avatar

could be a bad radiator i know it sounds odd but the the trany fluid is pumped through the radiator or u could just be leakin fluid check it out and check the radiator

User Avatar

How to remove ignition switch on a 91 Mazda Navajo


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.