0
the clutch and the brakes share the same master cylinder on my 1991 protege dx 1.8 sohc
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the clutch master cylinder on 2007 Mazda 3?
how do you bleed the clutch master cylinder in a 2005 mazda 3
Is there a hydraulic clutch on a Mazda Miata?
Yes there is a hydraulic clutch on the miata. Just to the outside of the firewall, near the brake master cylinder is the clutch master cylinder and resevoir.
How do you fix Mazda mx 6 clutch sinking to the floor?
First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.
Why does your Mazda b2000 86 not have pressure in the clutch pedal?
No fluid in the master cylinder
Is the clutch adjustable on a Mazda rx7 1991?
no it is hydraulic.dont know what your problem is but check clutch master cylinder and slave cylinder operation,if ok may just be a bad clutch
How long does a clutch last on Mazda Protege?
I had to change the clutch at 120,000 kilometers.
Clutch went out on 1990 Mazda rx7 It was fine then got hard to shift and clutch lost spring. It has fluid What could it be?
Check for bad clutch master cylinder or slave cylinder.
Where do you add brake fluid in a 1990 Mazda protege?
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
Where is cylinder 2 located on a 2003 Mazda 6?
location cylinder 2 mazda protege
Picture of clutch cable on 1990 Mazda 323?
there is no clutch cable. it has a hydraulic clutch. there will be a clutch master cylinder on the firewall near the brake M/C. a hydraulic hose will connect that to the clutch slave cylinder on or near the tranny. the slave cylinder pushes on a fork (lever) that disengages the clutch.
Why does the clutch pedal gets stuck on an 1989 Mazda Rx7?
Clutch master cylinder might be blown out. this is located in the engine bay, the top right.
How do you adjust clutch on 1995 Mazda Protege LX which has to be pushed all the way in and shifted carefully and hydraulic cylinder cannot be located under hood for adding fluid?
your brake master cylinder serves as your slave cylinder resevior. If either your master or slave clutch cylinders are going bad, it may not do any good to try to adjust them. But the slave cylinder has a bleeder screw and the process of bleeding the clutch is similar to bleeding the brakes. In short, open the bleeder screw when clutch is being pressed, and close it when clutch is fully pressed. Have a tube on the bleeder screw going into a jar of brake fluid so you can see bubbles coming out of the slave. The slave is mounted on the bottom of the transmission and the master clutch cylinder is on the firewall behind and below the battery, it has a tube that goes to the lower right rear of the master brake cylinder reservoir to get it's fluid supply.
