answersLogoWhite

0


Best Answer
Copy

what part of the arm need repairing? in fact i just re did my wiper arms on my 89 lesabre. they became frozen to the window and i turned on the wipers and it stripped the inner teeth that hang the arm onto the wiper drive. i went to our local bone yard and got 2 new ones that match mine for less than 6 dollars. its the best way to do it. to take the arm off, or install the arm there is a little tab that sticks out of the arm,bend the wiper at the spring recoil just far enuf so ya dont break it take a flat head screwdriver and gently pry that tab outward then release the arm back down, that tension on the spring in the arms will keep that tab from locking the wiper blade back to the drive sprocket. slowly wiggle back and fourth whie pulling up and it will release.!!!!!!!! after i figured out how that little locking tab works, it took me about 3 min to remove my old stripped wiper ARMS ,re attach the wiper blades and install them back on my car 10 min tops... ..

User Avatar

Wiki User

โˆ™ 2015-07-15 20:49:21
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you repair the wiper arm on a 1994 Buick LeSabre?
Write your answer...
Submit

Related Questions

Which relay is the starter relay on a 1994 Buick lesabre?

Which relay is the starter relay on a 1994 buick lesabre


Where is the fuel pump relay located on a 1994 Buick lesabre?

fuel pump relay location in 1994 buick lesabre


Where is the computer in a 1994 Buick lesabre?

On my 1994 Lesabre it is under the dash about center at edge of carpeting


Will a 1992 Buick lesabre cassette radio fit work in a 1994 Buick lesabre?

Yest, the Buick LeSabre from 1992-1994 is the same exact car, inside, outside, underside. Everything is identical, except say for the trim packages and options you get on them. Therefore, yes the cassette radio from a 1992 LeSabre will work in a 1994 LeSabre.


How do you take off a windshield wiper off on a 1994 Buick LeSabre?

The 1994 Buick LeSabre has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you replace wipers on a 1994 Buick lesabre?

The 1994 Buick LeSabre has fairly unique "1/4" side lock" wiper arm attachments. See the Sources and Related Links section below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Its very easy.


Why would the window wiper motor work but the wipers do not move there is a clicking sound on 1994 buick lesabre?

the arm that controls the wiper arms has fallen off the motor.there is usually a clip that holds it on.Look under the cowl for access


How do you replace a rear wheel bearing on a 1994 Buick LeSabre?

I have a shimmy or small vibration while driving the interstate on my 1994 buick lesabre - if i was to check the front and rear bearings - how would i do that and what would i look for


FAQ10what would cause a 1994 Buick LeSabre v6 to shut off my self going down the road?

what would cause a 1994 Buick LeSabre v6 to turn off going down the road.


What type of brake fluid do you use in a 1994 Buick LeSabre?

Dot 3


How to replace a serpentine belt on 1994 buick lesabre?

replace tension put it on


How do you replace a wheel bearing on a 1994 Buick LeSabre?

AnswerFront or rear?front


How do you repair the cruise control on a 1994 Buick Lesabre Limited?

First you need to troubleshoot the 1994 LeSabre cruise control. Check the fuse, the cruise switch, the linkage, to find where the problem is. Check the vacuum lines on the engine as a vacuum leak can cause the cruise to not work properly.


Will doors on a 1994 Buick Lesabre fit on a 1997 Buick lesabre?

1997, 98 and 99 lesabres are supposed to bigger inside so check with a dealer or wrecking yard.


Where can you find the thermostat on a 1994 Buick LeSabre?

Should be at the end of the upper radiator hose.


Does a 1994 Buick lesabre with a 3.8 liter engine have a timing chain or belt?

chain


How do you change fuel pump on 1994 Buick lesabre limited?

Drop the fuel tank.


Does a Buick LeSabre have a door lock fuse?

Yes, a 1994-1999 Buick LeSabre has a door lock fuse. It is a MIN20 type of fuse (mini, blade-style, yellow, 20 amp).


What size speakers are in the front dash of a 1994 Buick Lesabre?

they are 4x6 rear speakers are 6x9


Where is the fuse for the radio on a 1994 Buick LeSabre?

fuse #44 behind left side of dash


What kind of oil does a 1994 buick lesabre take?

10w30 says it right on the oil cap.


Wiper size for buick le sacbre 1994?

The 1994 Bucik LeSabre wiper blade sizes are 22" wiper blades on both sides front. Do not buy by length-only however. See the Sources and Related Links section below for more information. Since there are over 22 different wiper arm attachments - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.


What sizes are the front speakers in a 1994 Buick lesabre with the concert surround ii option?

i got a 95 buick lesabre and it has concert surround ii, and they were 6 1/2s, but im not so sure for a 94.


What type of diagnostic code scanner is required for a 1994 Buick LeSabre?

94 buick lesabre was right at the change over( obd1 to obd2) some have an obd2 connection with an obd1 computer. this can only be read by buick garages. go to auto zone or checker auto and they can tell you.


How do you replace the wiper blades on a 94 Buick Le Sabre?

The wiper blades on a 1994 Buick LeSabre should both measure 22 inches in length. Start on the driver's side wiper, and find the small clip holding the blade onto the arm. Disconnect the blade by unclipping that small clip. To install the new blade, line up the hook in the right direction and lock it into place. The same procedure can be taken on the passenger side blade.