Take off intake tube between air box and throttle body(TB) pull evap solenoid out of it and just push it out of your way and also unplug pcv hose from intake tube. EGR is located underneath TB it has a square 6-pin connector on it. Unplug the conector and then unbolt the two 12mm bolts to free EGR valve. Be careful not to lose or damage the metal gasket that goes between egr valve and TB instal in reverse order
how much does it cost to replace to egr valve on the 2002 mazda protege
Were is the egr on a 1992 mazda protege
It should be underneath the throttle body on the back of the intake manifold
Were is the egr valve on a 99 Mazda progege 1.8
The EGR is right under the throttle body. It has like a little black top. You have to remove the intake hose to see it. Its a pain to get to and remove.
Remove the vacuum line than attach it to the EGR. With the valve open and lifted, suck on the line and spray on the valve. You should also have a new gasket to replace the existing one. Check all the hose connections
9 times out of 10 is a your EGR valve stuck open due to rust, do a google search for protege low idle you'll find it! good luck
2003 4.3's do not have an egr valve.
The 2003 Pontiac Montana EGR valve is located on the firewall. The valve will be on the driver side of the firewall.
It's bolted right on top of the egr valve which is on the back of the engine under the throttle body there will be a small vacuum line going into where the egr valve bolts into the intake
An EGR valve usually can't be cleaned. If you want to try to clean it, us Combustion Chamber Cleaner on it. If this doesn't work then the cost of an EGR Valve from the dealer is about $275.00 Can. I have had to replace my EGR valve about 2 months ago and I wasn't able to find an after market replacement.
Yes, it does have an EGR valve.