Thermostat Removal & Installation 1. Disconnect the negative battery cable. 2. Drain and recycle the engine coolant. 3. Remove the Power Steering reservoir support bracket. 4. Remove the upper radiator hose at the thermostat housing. 5. Remove 2 thermostat housing retaining bolts and remove the housing. 6. Remove the thermostat and O-ring from the lower intake manifold. Discard the O-ring. To Install: 7. Clean the O-ring sealing surfaces. 8. Install a new O-ring, on the thermostat and position the thermostat in the lower intake manifold. 9. Place the thermostat housing on the lower intake manifold and install 2 retaining bolts. Tighten the bolts to 15-22 ft. lbs. (20-30 Nm). 10. Install the power steering reservoir support bracket. 11. Fill the engine cooling system. 12. Connect the negative battery cable. 13. Start the engine and allow it to reach normal operating temperature while checking for coolant leaks. 14. Road test the vehicle and check for proper engine operation. 15. Check the coolant level and add if necessary.
How do you replace the ignition switch on a 2000 ford expedition?
Where is the airbag module on the 2000. Ford expedition
To replace a thermostat on a 2000 Ford F-250 V10, drain the radiator. Locate the thermostat on the top hose assembly and remove the screw. Replace the thermostat and refill the radiator.
how to change a thermostat on a 2004 ford expedition
Take the ford to a mechanic !!
it is behind the thermostat in the water jacket
How do I replace thermostat on 97 Ford van
Replace thermostat on 91 ford eacort
go to strutmasters.com
How do you replace a radiator on 2003 ford expedition?
thermostat on a ford 2002
You have to be more specific. Quote your question; "How do you replace a 2000 Ford Expedition cup holder?" If I was a smart @ss, I would answer; "The installation is the reverse of the removal." But I really don't know so. I would call the dealer and ask them.