Steering and Suspension
Mercury Topaz
Oldsmobile Cutlass Supreme
Ford Ranger XLT

How do you replace a control arm on a 1994 Mercury Topaz?


Top Answer
User Avatar
Wiki User
2006-05-29 03:18:14
2006-05-29 03:18:14

If you go to , click on vehicle repair on the left, check the year, then mercury, then topaz. It will bring up repair guide for 84-94. Next click on suspension and steering, then front suspension, then lower control arm. Save this site, it's great for any repairs you have. You don't have to login, and there are detailed pics :)


Related Questions

does some one know the fireing block numbers for a 1994 mercury topaz 4

Take out the olod radiator, put in the new one and done

The 1994 Mercury Topaz has a chain and not a belt.

You have to remove the strut assembly from the car, and need the spring compressor to remove the spring to remove the shock.

Sorry , no ansewer because no Topaz 1995 ; last production was 1994.

Should be at the lower rear of engine on driver's side

open the drivers door the answer is there on a sticker. every car has this.

How do you replace the timing chain on a 1994 mercury grand marquis

i have an 87 topaz where the alternator goes bad also. have replaced it twice. it is just a common problem in the topaz's

what is the cost to replace the rack and pinion on a 1994 mercury sable

look in the glove box, there should be a sticker that shows everything

Big job. You have a choice, remove the whole engine with the transmission, or just the transmission. Either way you have to be equipped with the right tools. Best is to find someone to do the job for you. It will cost.

Just follow the positive battery cable, not far, and there it is.Under $ 20. to replace.

Follow the Upper Hose toward the motor and when it ends, that's the housing.

Take out the bench seat, and remove the back, take a look. Holes are small.

To replace lamps the cluster must be removed.

mabe its your clutch activation sensor that isn't working it happend on 2 of my cars

Should be around the oil filter, check the manual if not there.

Unplug connector use jumper wire from one side of connector to the other, that should do it.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.