2004 Jeep Liberty turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
trouble putting right front signal bulb in.
on what car
Check the fuses; if fuses good, then check the wiring for damage
Check the fuse for the wipers and replace the turn signal bulb.
Get a creeper and go at it from the bottom, all of what you need is right there.
i need to replace a throttle sensor and put a throttle body rebuild kit in
One of the front blinker bulbs is burnt out. Replace the bad bulb and the blink should function normaly. you have a front right turn signal bulb that is burned out. the resone it blinks fast is there is less load on the flasher .
First pop your hood. After you raise the hood, and your looking at the front headlights. Directly above the headlights. In each corner of the headlight is a screw. remove that screw and pull the signal light right out. turn it over to replace old bulb. Once your done reinstall turn signal. Then tighten screw back!
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.
I would replace the turn signal switch.
Replace the signal flasher relay assuming you have physically seen front and rear, left and right signal bulbs flash.
says how to do it clearly in the owners Manuel but all u have to do is open the hood clip it off