Chevy Corsica
Heater Cores and Blower Fans
Ford Bronco XLT

How do you replace a heater core in a 1995 Chevy Corsica?

272829

Top Answer
User Avatar
Wiki User
2011-09-12 20:44:19
2011-09-12 20:44:19

A Haynes or chiltons manual has the how to. Or do a search for a forum for Chevy corsica specific

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The side view mirror on a 1995 Chevy Corsica is mounted by screws. Remove the screws and panel for the mirror on the inside of the vehicle. Pull and replace the unit.

User Avatar

Under dash, near firewall, passenger side.

User Avatar

where would i locate the fuse for the fuel pump on a 1995 Chevy corsica

User Avatar

I find that Autozone is very helpful in answering automotive questions.

User Avatar

Because its a Chevy corsica not a ford corsica!!!!!

User Avatar

Place a drip pan beneath your 1995 Chevy Corsica oil pan. Remove the oil pan plug. Allow the oil to completely drained out. Replace the oil pan plug to its original position. Fill the motor with oil.

User Avatar

You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.

User Avatar

the library should have a shop manual to make copies of for your vehicle...:)

User Avatar

You dont. You just have to remove the glove box insert.

User Avatar

you may need specail tools and a welder to do it right, otherwise check out the local library for a shop manual for free d

User Avatar

Big job==TAke it to a garage or get a manual and do it right

User Avatar

how do I replace block heater on 1995 dodge ram 2500

User Avatar

I have not received an answer to my question, "How do you replace a heater core in a 1995 Plymouth Voyager SE? When can I expect an answer? Thank you!!! nellkat60

User Avatar

Check out the top of the fuel tank and the tubes leading to it.

User Avatar

put the back wheels on ramps or a lift if you got one and lossen the straps that hold the tank in place then set it on the gound in order to get the pump out,

User Avatar

Here is a link with pictures, tools needed and everything to do the job. http://www.v6z24.com/howto/heatercore

User Avatar

How do you replace a break light switch on 1995 Chevy Tahoe

User Avatar

you need to remove the taillight assembly. you will see all the bulbs.

User Avatar

It is located in the front of the motor just above the starter.

User Avatar

The spindle is what the front wheel is mounted on. It is the shaft that the wheel bearing slides up on.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.