You must remove the instrument panel from the vehicle, and then remove the HVAC housing. The heater core is inside the HVAC housing. This can be a pretty big job, so unless your willing to spend some serious time with it, you may want to leave it to a professional. Your local Dodge dealership should be able to handle this repair for you with no problem. Pulling the instrument panel on those cars was quite common to change evaporators back in the day. I can't say I've seen very many heater cores go bad in them though.
how do I replace block heater on 1995 dodge ram 2500
what does rack and pinion steering consist of and do on a 1995 Dodge Intrepid?
trying to replace the starter on a 1995 3.3 dodge intrepid! what problems if any can i anticipate?
The 1995 Dodge Intrepid has two motor mounts. One on the left and one on the right.
You will need to remove the water lines from your 1995 Dodge Dakota truck heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
The fuel filter 1995 dodge Intrepid is on the passenger side. The filter is towards the back of the car.
The trunk release in a 1995 Dodge Intrepid is under the dashboard on the driver's side. There is also a remote trunk release.
This is an excellent article on how to replace the inner tie rod bushings, which are a common problem. http://www.allpar.com/fix/intrepid-steering.html
It could, it was an option.
The 1995 Dodge Intrepid does not have and ODB2 port, the Intrepids didn't introduce ODB2 until 1996.
you can't, it is not adjustable.
The voltage regulator on a Dodge Intrepid is inside the engine computer.
No, you need a 2.7, or preferably a 3.2 or 3.5 liter between 1998 to 2004 for this car. It will probably cost more than the car is worth to replace the motor at this point.
it could havebeen built with it or with out
No, it mounted forward.
Your thermostat is possibly not opening up. Replace and flush and then recheck. Good luck.
Step by step detailed instructions but no videos are available......
Begin by removing the valve cover from your 1995 Dodge. Remove the valve cover gasket and clean the surface. Put the new gasket on and return the valve cover to its original position.