It's in the centre of the dashboard, right below the windshield. The bottom of the dash, sides and top of the dash have to come off. Drop the steering column onto the drivers seat, unplug all the wiring harnesses to the brake switch, 60 way connector, fuse panel,and all other connectors for airbags, turn signals etc etc.... take out the radio and heater control and console (if equipped). Remove the heater and AC lines in the engine compartment. Undo the 3 bolts in the engine compartment connecting the module to the firewall and the three bolts inside the car holding the module to the firewall. Pull the module out and the core is on the left side top. It's about a 15 hr job for a first timer.
Where can I get a diagram of a 1996 Dodge Intrepid cooling system?
its a in tank fuel filter replace the sock on the fuel pump
diagram for timing marks on 1996 dodge intrepid 3.5
i found searching around from 375 to 450
Which do you mean? African or European Intrepid?
5w30 or 10w30
Dodge does not use inertia/reset switches.
It is an integral part of the starter.
Yes. You can use automatic transmission fluid in the power steering on a Dodge Intrepid.
The 1995 Dodge Intrepid does not have and ODB2 port, the Intrepids didn't introduce ODB2 until 1996.
You have to remove the pan, there is no drain.
it is controlled by the ecm
No it does not. I wish mine did though!
The 1996 Dodge Intrepid main bearing torque specification is 180 pounds. The main bearings should be torqued in 60 pound intervals.
No, it will not, design is much too different to make it feasable. For a 2000 intrepid you must use a 1998-2001 engine. Check out dodgeintrepid.net for a ton of info on these cars.
If same size engine, yes.If same size engine, yes.
trunk light is located in the trunk