0
it has 2 or three bolts holding the housing to the side of the engine block.You will have to remove the long support bracket to get access to these bolts, not hard just need a long extension for one of them.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you fix a oil leak on a 1997 kia sportage 4x4 leaking around the oil filter?
replace the housing o ring
Is there a gasket or o-ring for oil filter housing on a 2001 Kia Sportage 2.0l?
yes there are 2 o-ring gaskets against the engine block where the oil filter housing attaches.
Oil is running out by the oil filter housing 5.4 engine?
check that the O ring was replaced when oil filter was changed. id O ring is good and filter is tight, and housing still leaking, replace filter housing
Remove oil filter on a 2007 vw beetle 2.5 5 cylinder?
Remove the 4 screws from the rock guard on the front of the engine. Using a universal oil filter wrench, turn the filter housing counter-clockwise until loose then remove by hand. Replace the o-ring in the housing cap and replace the filter inside the housing. I had luck placing he filter into the base on the engine first and then placing the housing cap onto it. Tighten and replace rock shield... Good Luck!!
How do you change a Chevy hhr oil filter?
Locate the filter housing and remove the drain plug allowing the oil to drain. Remove the filter cap, O-ring and cartridge and clean and examine them for damage. Install the new housing and O-ring in the same position and replace any damaged parts. Slide the O-ring around in its groove until it straightens out.
Location of oil filter on 3.3 liter V6 2008 Hyundia Santa Fe?
Take the 4-10mm nuts off the plastic shroud, remove shroud. With a oil filter wrench (or by hand) unscrew (CCW) filter housing. Remove paper filter discard, insert new filter, replace large o-ring on filter housing, screw housing back on till it bottoms out. Replace shroud, tighten 4-10mm nuts. Dispose of filter properly
How do you replace headlamps on 1999 Kia Sportage?
pop hood, go in behind lamp and follow thick wiring cable to back of lamp and turn ring housing until it comes loose,then pull out bulb.
Where is the fuel filter located and how do you replace it on a 1985 Ford Ranger?
It is located in the drivers side frame rail. It is hidden behind a metal debris guard. Twist off the black fuel bowl of the filter housing (after you have relieved the fuel pressure) and replace the disk filter and o-ring.
How do you change the oil and filter in a 1998 Jetta VR6?
Instead of a traditional canister filter like you may have seen on most cars, including a 4 cyl Jetta of the same year this car has a filter housing with a replaceable filter elment. The filter is located on the front of the engine, accessible from below. There is a drain plug that can be removed with a 6mm hex key. The filter housing is removed with a 36mm socket. Your new filter element should come with a replacement o-ring for the housing, apply a little new (engine) oil to the o-ring and replace the old one in the housing. Drop the new filter element in the housing and reassemble. src: http://www.gti-vr6.net/library/engine/changing_oil.html
What is the procedure to replace a cartridge filter?
Remove the cover holding the filter in the cartridge. Remove the old filter and wipe everything clean. Make sure to remove the old rubber O Ring. Replace the O Ring with the new one and install the new filter. Apply a thin layer of oil on the new O Ring. Replace the cover and tighten snugly. Do not over tighten.
How do you replace the fuel filter on a 2003 Dodge Ram with a Cummins engine?
Push the yellow lever to the left to drain the fuel from the filter housing and then push it back to the original position. Unscrew the lid of the filter housing and pull out the filter (it is attached to the lid) Remove the filter from the lid by pulling it off. Remove the o-ring from the lid Reattach the new filter and o-ring to the lid Place the new filter and lid back into the housing and hand tighten. Before you start the truck: Cycle the key to the on position (do not start the truck) and wait until you hear the fuel pump stop, do this 3 or 4 times to prime the fuel system. Now you are ready to start the truck!
Where to install oil filter gasket on 2005 cavalier?
oil filters normally have a o ring or a d ring not a gasket. and it is installed on filter itself if you have the spin on type or around the filter cap / screw in housing if you have the cartridge type
